Brian Durant wrote:
"SIS 900 Internal MII PHY Transceiver found. at address 1
Using transceiver found. at address 1 as default.
SIS 900 PCI Fast Ethernet at 0xe400, IRQ 11, 00:30:67:06:4f:86"
<Response to "grep eth0 /etc/network/interfaces" was nothing.>
Added the two lines in /etc/network/interfaces restarted the network
and tried again. Same result - nada - zip -zilch response. No
response with /sbin/ifconfig either. Thanks for all your time so far.
Is there any place that we can go from here? I did a sort of default
full install with tasksel and dselect. Got a lot of stuff I didn't
want, but even the stuff that I do want will not do any good if I
don't get this @£5#+* eth0 working.
Post the contents of "/etc/networking/interfaces" for us if you would,
please.
Also, the result of "ls -l /sbin/ifconfig".
Kent