Re: i810 in X 4.1/2
Thanks a lot for your response, Branden. More than that, thanks for
all your work in this area.
|> In XFree86 4.0.1, at least, the amount of video RAM available
|> allocated in the absence of a VideoRam line on i810 machines was
|> something like 512kB.
|>
|> Too little for most people's purposes.
OK, do I understand from this that, for i810 controllers at least, the
amount of video RAM can be set, in principle, as one likes? This is
what I gathered from some of the posts I read, but it's not obvious
from the documentation at the XFree86 site.
|> > On a separate (I think) matter: there's a slight but annoying
|> > flicker at the moment on the screen. How might I eliminate this?
|>
|> Don't know about that.
|>
|> What refresh rate is being used?
In the config file:
Section "Monitor"
Identifier "Generic Monitor"
HorizSync 28-49
VertRefresh 43-72
Option "DPMS"
EndSection
>From the log-file:
(--) I810(0): Virtual size is 1024x768 (pitch 1024)
(**) I810(0): Default mode "1024x768": 65.0 MHz, 48.4 kHz, 60.0 Hz
(II) I810(0): Modeline "1024x768" 65.00 1024 1048 1184 1344 768 771 777 806 -hsync -vsync
Thank you very much,
Jim
Reply to: