Re: Creating pdf documents under woody
On Thu, Mar 04, 2004 at 08:28:30PM -0500, Antonio Rodriguez wrote:
> On Fri, Mar 05, 2004 at 02:19:11AM +0100, Jonathan Schmitt wrote:
> >
> > ...
>
> after you have the tex source written, do the following:
>
> tex file.tex; dvips -o file.ps file.dvi; ps2pdf file.ps
This works too (dvips instead of dvi2ps as some other poster suggested),
up until the time I use xpdf. Then I get the same type 3 fonts error
message I copied into another sub-thread.
So is this caused by xpdf not being up to date with the rest of the
system? (more likely I presume) or is it something else that could
cause the files created this way to be unintelligible to a large part
of pdf readers out there? In other words, I should probably stick with
the "print to file" way (and the presumably type 2 fonts?).
A.
Reply to: