Re: Unable to use network card with 2.4.19
On 2002.10.10 19:12 Shyamal Prasad wrote:
After boot up, before you 'ifdown eth0' what do you see with ifconfig?
Also, during the boot process you should see a line like "Configuring
network interfaces...." followed by "done". Anything interesting in
between those two lines?
I scanned dmesg and didn't see anything with the above text. Instead, I
do see, after loading yenta_socket, it loads tulip2 and reports:
eth0: Digital DS21143 Tulip rev 48 at 0x4000, 00:80:C8:42:2A;A7, IRQ 11.
... // some other stuff
eth0: Setting half-duplex based on MII#0 link partner capability of
0000.
And that's it. The card is a D-Link DFE-660.
One more thing I'd try is 'ifdown -a' followed by 'ifup -a' to see if
that is any different (probably not, but heck, I'm just guessing....)
I'll try that tonite when I leave work. I don't want to do it now since
it's working and I need it to keep doing that at the moment. ;)
--
Darryl L. Pierce <mcpierce@telocity.com>
Visit the Infobahn Offramp - <http://welcome.to/mcpierce>
"What do you care what other people think, Mr. Feynman?"
Reply to: