Re: How to can make a partition in my hard disk ?
On 10/25/22, David Christensen <dpchrist@holgerdanske.com> wrote:
> On 10/25/22 19:22, Max Nikulin wrote:
>> On 26/10/2022 04:34, William Torrez Corea wrote:
>>> Model Family: Toshiba L200 (SMR)
>>
>> I would not consider a HDD with shingled magnetic recording as a storage
>> to install OS.
>
>
> +1
>
> I prefer SSD's for OS drives.
>
> I have been careful not to buy SMR drives, but AIUI they are cost
> effective for large sequential write workloads -- e.g. music/ photo/
> video/ ISO files, backup/ archive tarballs, images/ clones, etc..
>
>
>> ... it has another problem:
>>
>>> 3 Spin_Up_Time POS--K 100 100 001 - 1318
>>> 4 Start_Stop_Count -O--CK 100 100 000 - 606
>>> 193 Load_Cycle_Count -O--CK 093 093 000 - 75472
>>
>> It has quite aggressive policy to unload heads. It happens approximately
>> than once per minute. Following read operations may have noticeable
>> delay. At first I suspected delays due time required to spin up stopped
>> disk, but in your case Power_Cycle_Count = Start_Stop_Count, so your
>> system keeps the disk spinning.
>>
>>> 191 G-Sense_Error_Rate -O--CK 100 100 000 - 48930
>>
>> Frequent shocks, vibration, unstable base may force heads unloading and
>> following latency in UI.
>
>
> Good insights.
>
> Here are some other smartctl(8) report values that might be related to
> slowness:
>
> Device Statistics (GP Log 0x04)
> Page Offset Size Value Flags Description
> ...
> 0x02 0x010 4 48930 --- Overlimit Shock Events
> ...
> 0x03 0x028 4 36105 --- Read Recovery Attempts
>
> SATA Phy Event Counters (GP Log 0x11)
> ...
> 0x0009 4 106670 Transition from drive PhyRdy to drive PhyNRdy
>
> The drive operating vibration specification is only 1.0 G (5 to 500 Hz):
>
> https://www.toshiba-storage.com/products/toshiba-internal-hard-drives-l200/
>
> I wonder if the OP is using the laptop in a moving vehicle, while riding
> public transportation, or is handling it roughly (?).
>
>
>> P.S. I have not managed to change heads unload timeout for Toshiba L200
>> using hdparm. In your case due to high G-Sense_Error_Rate increasing
>> timeout might be dangerous.
>
>
> So, you own one of these drives?
>
>
> David
>
>
Only use my laptop in my desktop and when i going to sleep in a night
table for watch a movie. When i am going to university i use the
laptop but in the car or bus the laptop is inactive.
--
With kindest regards, William.
⢀⣴⠾⠻⢶⣦⠀
⣾⠁⢠⠒⠀⣿⡁ Debian - The universal operating system
⢿⡄⠘⠷⠚⠋⠀ https://www.debian.org
⠈⠳⣄⠀⠀⠀⠀
Reply to: