Re: [Debian] hdparm
Hallo,
* Andreas Behnert <abehn@gmx.net> [010202 21:54]:
> Alle vier IDE-Platten ordentlich im Bios anmelden, so daß sie beim Booten
> erkannt werden.
Genau da beginnt schon das Problem.
Meine neueste Platte (60GB) wird vom BIOS nicht erkannt. Die Erkennung
bricht immer ab.
Ich habe die anderen 3 Platten angemeldet.
Kann das auch ein irq-Problem sein?
Folgende Meldungen beim Start:
Feb 3 01:25:04 debian kernel: Kernel command line: auto
BOOT_IMAGE=linux ro root=802 pci=autoirq
Feb 3 01:25:04 debian kernel: PCI: Unknown option `autoirq'
######Der Eintrag stimmt so nicht. pci_autoirq tuts aber auch nicht...#
######Wurde vorher vom Kernel empfohlen...#
...
Feb 3 01:25:04 debian kernel: block: queued sectors max/low
84232kB/28077kB, 256 slots per queue
Feb 3 01:25:04 debian kernel: Uniform Multi-Platform E-IDE driver
Revision: 6.31
Feb 3 01:25:04 debian kernel: ide: Assuming 33MHz system bus speed for
PIO modes; override with idebus=xx
Feb 3 01:25:04 debian kernel: VP_IDE: IDE controller on PCI bus 00 dev
39
Feb 3 01:25:04 debian kernel: VP_IDE: chipset revision 6
Feb 3 01:25:04 debian kernel: VP_IDE: not 100%% native mode: will probe
irqs later
############???????????????#################
Feb 3 01:25:04 debian kernel: VP_IDE: VIA vt82c586b IDE UDMA33
controller on pci0:7.1
Feb 3 01:25:04 debian kernel: ide0: BM-DMA at 0xe000-0xe007, BIOS
settings: hda:DMA, hdb:DMA
Feb 3 01:25:04 debian kernel: ide1: BM-DMA at 0xe008-0xe00f, BIOS
settings: hdc:DMA, hdd:DMA
Feb 3 01:25:04 debian kernel: hda: ST320430A, ATA DISK drive
Feb 3 01:25:04 debian kernel: hdb: IBM-DHEA-38451, ATA DISK drive
Feb 3 01:25:04 debian kernel: ide: Assuming 33MHz system bus speed for
PIO modes; override with idebus=xx
Feb 3 01:25:04 debian kernel: hdc: Maxtor 96147H6, ATA DISK drive
Feb 3 01:25:04 debian kernel: hdd: IBM-DTTA-351010, ATA DISK drive
Feb 3 01:25:04 debian kernel: ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Feb 3 01:25:04 debian kernel: ide1 at 0x170-0x177,0x376 on irq 15
Feb 3 01:25:04 debian kernel: hda: 40079088 sectors (20520 MB) w/512KiB
Cache, CHS=19880/32/63, UDMA(33)
Feb 3 01:25:04 debian kernel: hdb: 16514064 sectors (8455 MB) w/472KiB
Cache, CHS=8191/32/63, UDMA(33)
Feb 3 01:25:04 debian kernel: hdc: 120064896 sectors (61473 MB)
w/2048KiB Cache, CHS=119112/16/63, UDMA(33)
Feb 3 01:25:04 debian kernel: hdd: 19807200 sectors (10141 MB) w/466KiB
Cache, CHS=19650/16/63, UDMA(33)
##############das war noch nicht die Einstellung in S99local,oder?#####
Feb 3 01:25:04 debian kernel: Partition check:
Feb 3 01:25:04 debian kernel: hda: hda1 hda2 < hda5 >
Feb 3 01:25:04 debian kernel: hdb: hdb1 < hdb5 >
Feb 3 01:25:04 debian kernel: hdc: hdc1 < hdc5 >
Feb 3 01:25:04 debian kernel: hdd: hdd1 <hdd: dma_intr: status=0x51 {
DriveReady SeekComplete Error }
Feb 3 01:25:04 debian kernel: hdd: dma_intr: error=0x84 {
DriveStatusError BadCRC }
Feb 3 01:25:04 debian kernel: hdd: dma_intr: status=0x51 { DriveReady
SeekComplete Error }
Feb 3 01:25:04 debian kernel: hdd: dma_intr: error=0x84 {
DriveStatusError BadCRC }
Feb 3 01:25:04 debian kernel: hdd: dma_intr: status=0x51 { DriveReady
SeekComplete Error }
Feb 3 01:25:04 debian kernel: hdd: dma_intr: error=0x84 {
DriveStatusError BadCRC }
Feb 3 01:25:04 debian kernel: hdd: dma_intr: status=0x51 { DriveReady
SeekComplete Error }
Feb 3 01:25:04 debian kernel: hdd: dma_intr: error=0x84 {
DriveStatusError BadCRC }
Feb 3 01:25:04 debian kernel: hdc: DMA disabled
Feb 3 01:25:04 debian kernel: ide1: reset: success
Feb 3 01:25:04 debian kernel: hdd5 hdd6 >
Feb 3 01:25:04 debian kernel: SCSI subsystem driver Revision: 1.00
Feb 3 01:25:04 debian kernel: PCI: Found IRQ 4 for device 00:08.0
Feb 3 01:25:04 debian kernel: IRQ routing conflict in pirq table for
device 00:08.0
##################Was ist pirq table???######
Feb 3 01:25:04 debian kernel: (scsi0) <Adaptec AHA-294X Ultra SCSI host
adapter> found at PCI 0/8/0
devices...blabla...
blabla...
Beim manuellen Start von xawtv neben diversen anderen Meldungen
folgende:
Feb 3 01:29:05 debian kernel: PCI: Found IRQ 9 for device 00:0a.0
Feb 3 01:29:05 debian kernel: IRQ routing conflict in pirq table for
device 00:0a.0
Feb 3 01:29:05 debian kernel: IRQ routing conflict in pirq table for
device 00:0a.1
...
Feb 3 01:29:05 debian kernel: bttv0: Hauppauge eeprom: model=61344,
tuner=Philips FM1216 (5)
Feb 3 01:29:05 debian kernel: bttv0: i2c: checking for MSP34xx @
0x80... found
Feb 3 01:29:05 debian kernel: bttv0: i2c: checking for TDA9875 @
0xb0... not found
Feb 3 01:29:05 debian kernel: bttv0: i2c: checking for TDA7432 @
0x8a... not found
Feb 3 01:29:05 debian kernel: tvaudio: TV audio decoder + audio/video
mux driver
Feb 3 01:29:05 debian kernel: tvaudio: known chips:
tda9840,tda9873h,tda9850,tda9855,tea6300,tea6420,tda8425,pic16c54
(PV951)
Feb 3 01:29:05 debian kernel: i2c-core.o: driver generic i2c audio
driver registered.
Feb 3 01:29:06 debian insmod:
/lib/modules/2.4.1/kernel/drivers/media/video/bttv.o: post-install bttv
failed
Feb 3 01:29:06 debian insmod:
/lib/modules/2.4.1/kernel/drivers/media/video/bttv.o: insmod
char-major-81 failed
Feb 3 01:29:06 debian kernel: bttv0: PLL: 28636363 => 35468950 ... ok
#########tv bild als root funzt. Aber nur unverständlich leiser Sound#####
#########als User dann Probleme mit video0-device...#########
#######dann verabschiedet sich hdc:
Feb 3 01:48:10 debian kernel: hdc: dma_intr: status=0x51 { DriveReady
SeekComplete Error }
Feb 3 01:48:10 debian kernel: hdc: dma_intr: error=0x84 {
DriveStatusError BadCRC }
Feb 3 01:48:10 debian kernel: hdc: dma_intr: status=0x51 { DriveReady
SeekComplete Error }
Feb 3 01:48:10 debian kernel: hdc: dma_intr: error=0x84 {
DriveStatusError BadCRC }
Feb 3 01:48:10 debian kernel: hdc: dma_intr: status=0x51 { DriveReady
SeekComplete Error }
Feb 3 01:48:10 debian kernel: hdc: dma_intr: error=0x84 {
DriveStatusError BadCRC }
Feb 3 01:48:10 debian kernel: hdc: dma_intr: status=0x51 { DriveReady
SeekComplete Error }
Feb 3 01:48:10 debian kernel: hdc: dma_intr: error=0x84 {
DriveStatusError BadCRC }
Feb 3 01:48:10 debian kernel: hdd: DMA disabled
Feb 3 01:48:10 debian kernel: ide1: reset: success
Da scheint also irgendwas im Argen zu sein....
Ich habe die Kiste auch ziemlich voll, alle Slots belegt, 5 Platten, CDR
und Brenner, Floppy...
Noch Ideen?
Gruß
Uli
--
-----------------------------------------------------------
Um sich aus der Liste auszutragen schicken Sie bitte eine
E-Mail an debian-user-de-request@lehmanns.de die im Subject
"unsubscribe <deine_email_adresse>" enthaelt.
Bei Problemen bitte eine Mail an: Jan.Otto@Lehmanns.de
-----------------------------------------------------------
673 eingetragene Mitglieder in dieser Liste.
Reply to: