Re: blade 1000 X config
- To: Tib <email@example.com>
- Cc: firstname.lastname@example.org
- Subject: Re: blade 1000 X config
- From: Dave Love <email@example.com>
- Date: Mon, 11 Jul 2005 18:38:15 +0100
- Message-id: <rzqu0j1uttk.fsf@loveshack>
- In-reply-to: <Pine.LNX.4.53.0507111017080.10087@altaica> (firstname.lastname@example.org's message of "Mon, 11 Jul 2005 10:19:09 -0500 (CDT)")
- References: <Pine.LNX.4.53.0507102149150.10087@altaica> <rzqackt1xep.fsf@loveshack> <Pine.LNX.4.53.0507110715270.10087@altaica> <email@example.com> <Pine.LNX.4.53.0507111017080.10087@altaica>
Tib <firstname.lastname@example.org> writes:
> I'm not familiar with either X or the blade's hardware.. I've always just
> run linux as an ssh/terminal host.
> Which should I use - or how should I check to see which is installed, I do
> have access to tty2 during this process to run commands from a shell?
I'm not sure what you're asking. If you're talking about a blade
1000, I assume the keyboard is USB, and the kernel in use is clear.
If you have a messed-up keyboard, the solution is to get in via ssh
(if it's set up) or the serial port (if that's set up). If you
installed via the console, I think the serial port gets set up as a
I think you do `dpkg-reconfigure console-data' to change the keymap.
Check the installation instructions, where I think it's mentioned.