Re: v100 ethernet problems
Justin A <justin@bouncybouncy.net> writes:
>> On Sun, 2004-03-14 at 17:41, Marc Horowitz wrote:
>>
>> > Problem 3: Full-duplex doesn't work right. At boot, the interface
>> > autonegotiates to 100baseTx-HD. If I use mii-tool to force it to full
>> > duplex, I see reduced throughput, and a transmit error on every packet
>> > is reported (but the packets are sent).
>> >
>> > Marc
>>
>> My ultra2 did this when it was plugged into my old 10mbit switch(it went
>> to 10 hd) If I forced it to 10 fd, it barely worked. Since I've gotten
>> a new 100mbit switch, I haven't had any problems
I've got an HP procurve 2524 managed 10/100 switch. I've tried many
combinations of settings on both ends, but I couldn't win. Specific
suggestions of settings are encouraged.
Marc
Reply to: