Re: ACPI sleep/hibernation mode
On Thu, May 08, 2003 at 04:59:15PM -0400, Andre Berger wrote:
> * Jim Richardson <warlock@eskimo.com>, 2003-05-08 15:07 -0400:
> > On Thu, May 08, 2003 at 08:48:52AM -0400, Andre Berger wrote:
> > > * Jim Richardson <warlock@eskimo.com>, 2003-05-08 08:11 -0400:
> > > > On Wed, May 07, 2003 at 06:03:35PM +0200, Emil Pedersen wrote:
> > > > > Mattia Dongili wrote:
> > > > > >
> > > > > > On Wed, 07 May 2003 17:28:53 +0200
> > > > > > Emil Pedersen <emilp@update.uu.se> wrote:
> > > [snip]
> > > > > It doesn't sound too hopeful then, unless I miss remember the free nv
> > > > > driver doesn't work with the geforce2go chip.
> > > > > But why would the driver need to support it, wouldn't it be enough to
> > > > > have the kernel remove it from run able processes before storing it's
> > > > > memory? But then again, that's probably not as easy as it sound:-/
> > > >
> > > > The nv XFree driver works fine with my I8100, Geforce2Go, with 32MB.
> > > > Suspends to RAM fine. Only thing it lacks is the ability to play ut2003
> > > > :)
> > >
> > > Which version are you using? With never drivers nvidia than the woody
> > > version I can't switch to the consoles because of scarry flickering.
> >
> > NVIDIA_kernel-1.0-3123, to be clear, S2R doesn't work (at least for me)
> > with the NVidia driver, only with the free nv one. But I can switch to
> > console with no flickering on the NVdrivers, just fine.
>
> Hmmph, doesn't work for me (Inspiron 2650)
>
> 01:00.0 VGA compatible controller: nVidia Corporation GeForce2 Go (rev b2) (prog-if 00 [VGA])
> Subsystem: Dell Computer Corporation: Unknown device 00f3
> Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
> Status: Cap+ 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
> Latency: 248 (1250ns min, 250ns max)
> Interrupt: pin A routed to IRQ 10
> Region 0: Memory at e0000000 (32-bit, non-prefetchable) [size=16M]
> Region 1: Memory at f0000000 (32-bit, prefetchable) [size=128M]
> Expansion ROM at <unassigned> [disabled] [size=64K]
> Capabilities: <available only to root>
>
> Would you be so kind as to post the relevant section in your
> /etc/X11/XF86Config-4, maybe I'm missing something? Are you using by
> any chance using kernel arguments like "vga=..."? (I don't)
>
> -Andre
Done, see <http://www.eskimo.com/~warlock/computers/XF86Config-4>
--
Jim Richardson http://www.eskimo.com/~warlock
Linux, because eventually, you grow up enough to be trusted with a fork()
Reply to: