[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: Upgrading u-boot on Dreamplug

On 06/15/2013 02:31 PM, Arnaud Patard (Rtp) wrote:

Philippe Clérié <philippe@gcal.net> writes:


On 06/12/2013 05:01 PM, Philippe Clérié wrote:

On 06/12/2013 09:27 AM, Martin Michlmayr wrote:

* Philippe Clérié <philippe@gcal.net> [2013-06-12 08:48]:

Thanks. I tried loading at 0x0080 0x0110 with the following error:

Wrong Ramdisk Image format
Ramdisk image is corrupt or invalid.


Can you post the full boot log?



I re-downloaded the images and tried again. This time I get the same as
the previous kernel. Below is the log.

U-Boot 2013.01.01 (May 10 2013 - 06:32:54)
Marvell-DreamPlug

SoC:   Kirkwood 88F6281_A1
DRAM:  512 MiB
WARNING: Caches not enabled
SF: Detected MX25L1605D with page size 64 KiB, total 2 MiB
In:    serial
Out:   serial
Err:   serial
Net:   egiga0, egiga1
88E1116 Initialized on egiga0
88E1116 Initialized on egiga1
Hit any key to stop autoboot:  0
Marvell>> usb start
(Re)start USB...
USB0:   USB EHCI 1.00
scanning bus 0 for devices... 5 USB Device(s) found
         scanning usb for storage devices... Device NOT ready
     Request Sense returned 02 3A 00
3 Storage Device(s) found
Marvell>> fatload usb 2:1 0x00800000 uImage
reading uImage
1607552 bytes read in 128 ms (12 MiB/s)
Marvell>> fatload usb 2:1 0x01100000 uInitrd
reading uInitrd
4853363 bytes read in 254 ms (18.2 MiB/s)
Marvell>> setenv bootargs console=/dev/ttyS0,115200n8


btw, might want to try with earlyprintk=ttyS0,115200 and see if there are
more messages

Arnaud
My bad. While adding earlyprintk I realized I had a typo in my original bootargs. Kernel boots just fine. I'm installing wheezy now. 

Sorry!

And thanks to everyone for the help.

--
Philippe

------
The trouble with common sense it that it is so uncommon.
<Anonymous>
Reply to: