Re: Upgrading u-boot on Dreamplug
Philippe Clérié <philippe@gcal.net> writes:
> On 06/12/2013 05:01 PM, Philippe Clérié wrote:
>> On 06/12/2013 09:27 AM, Martin Michlmayr wrote:
>>> * Philippe Clérié <philippe@gcal.net> [2013-06-12 08:48]:
>>>> Thanks. I tried loading at 0x0080 0x0110 with the following error:
>>>>
>>>> Wrong Ramdisk Image format
>>>> Ramdisk image is corrupt or invalid.
>>>
>>> Can you post the full boot log?
>>>
>>
>> I re-downloaded the images and tried again. This time I get the same as
>> the previous kernel. Below is the log.
>>
>> U-Boot 2013.01.01 (May 10 2013 - 06:32:54)
>> Marvell-DreamPlug
>>
>> SoC: Kirkwood 88F6281_A1
>> DRAM: 512 MiB
>> WARNING: Caches not enabled
>> SF: Detected MX25L1605D with page size 64 KiB, total 2 MiB
>> In: serial
>> Out: serial
>> Err: serial
>> Net: egiga0, egiga1
>> 88E1116 Initialized on egiga0
>> 88E1116 Initialized on egiga1
>> Hit any key to stop autoboot: 0
>> Marvell>> usb start
>> (Re)start USB...
>> USB0: USB EHCI 1.00
>> scanning bus 0 for devices... 5 USB Device(s) found
>> scanning usb for storage devices... Device NOT ready
>> Request Sense returned 02 3A 00
>> 3 Storage Device(s) found
>> Marvell>> fatload usb 2:1 0x00800000 uImage
>> reading uImage
>> 1607552 bytes read in 128 ms (12 MiB/s)
>> Marvell>> fatload usb 2:1 0x01100000 uInitrd
>> reading uInitrd
>> 4853363 bytes read in 254 ms (18.2 MiB/s)
>> Marvell>> setenv bootargs console=/dev/ttyS0,115200n8
btw, might want to try with earlyprintk=ttyS0,115200 and see if there are
more messages
Arnaud
Reply to: