Re: filesystem I'd?
On Mon, Dec 06, 2021 at 08:45:24PM -0800, Gene Heskett wrote:
> On Mon, 6 Dec, 2021 at 10:44 PM, David Wright <deblis@lionunicorn.co.uk> wrote:
>
>
> To: debian-user@lists.debian.org
> On Mon 06 Dec 2021 at 18:34:14 (-0800), Gene Heskett wrote:
> > Whats the name of the filesystem used on 64G micro-sd's labeled SDXC ?
>
> When you buy it? — exFAT. No guarantees after that.
>
>
>
> Then I recalled that writing an img or iso to it, replaces the file system. So dd wrote
> the .img to the raw card, and it looks all normal now. I haven't boot tested it yet,
>
> cuz I have a method worked out to install an older realtime kernel, but I'll do that
>
> in the morning to one of the two, then boot test it.
>
>
>
> If it doesn't work, I'll test the second card. If that one works, I'll have to mount my
>
> development system and sweat some blood building a newer kernel for it. It took a week
>
> or more to get 4.19.71-rt24-v7l+ #1 SMP PREEMPT RT running well on raspian buster. But
>
> it has an easier job here than there, here its running linuxcnc to run an 80 yo metal lathe,
>
Note - the version of Raspbian out there now is Bullseye - you might be
almost as well using Gunnar's Raspberry Pi builds for vanilla Debian.
>
> Where these card's are going back to they will be running a few tons of Cincinnati 4
>
> axis milling machine. Using linuxcnc of coarse. A machine big enough to start with
>
> a 600 lb block of good alu, and give you a toyota V8 engine block ready for parts
>
> about 8 hours later.
>
>
>
> Cheers, David.
>
> .
All best, as ever,
Andy C.
Reply to: