Upgraded kernels, now eth0 and framebuffer are gone

[M Carlock <deputycleric@yahoo.co.uk>]

I recently upgraded from woody to sarge per the
instructions (aptitude etc), which was successful.

However, after then upgrading the kernel from
2.2.20-idepci to 2.6.8-2-386, I found I could boot OK,
but I'd lost eth0 and the ATI framebuffer.

lspci can see both devices, but I'm at a loss as to
how to make the kernel see them again.

modprobe eth1349 seems to work OK.  modprobe eth16i
fails, no hardware found.  The card is a 3c905.

This must be a common question, but after a fair
amount of googling I haven't been able to spot an answer.


		
___________________________________________________________ 
To help you stay safe and secure online, we've developed the all new Yahoo! Security Centre. http://uk.security.yahoo.com