Setting up kernel-image-2.6.8-1-686 (2.6.8-9) ...
You are attempting to install a kernel version that is the same as
the version you are currently running (version 2.6.8-1-686). The
modules
list is quite likely to have been changed, and the modules dependency
file /lib/modules/2.6.8-1-686/modules.dep needs to be re-built. It can
not be built correctly right now, since the module list for the
running kernel are likely to be different from the kernel installed.
I am creating a new modules.dep file, but that may not be
correct. It shall be regenerated correctly at next reboot.
I repeat: you have to reboot in order for the modules file to be
created correctly. Until you reboot, it may be impossible to load
some modules. Reboot as soon as this install is finished (Do not
reboot right now, since you may not be able to boot back up until
installation is over, but boot immediately after). I can not stress
that too much. You need to reboot soon.
Please Hit return to continue.
Not touching initrd symlinks since we are being reinstalled (2.6.8-5)
Not updating image symbolic links since we are being updated (2.6.8-5)
A new kernel image has been installed, and usually that means
that some action has to be taken to make sure that the new
kernel image is used next time the machine boots. Usually,
this entails running a ``bootloader'' like SILO, loadlin, LILO,
ELILO, QUIK, VMELILO, ZIPL, or booting from a floppy. (Some
boot loader, like grub, for example, do not need to be run on
each new image install, so please ignore this if you are using
such a boot loader).
A new kernel image has been installed at /boot/vmlinuz-2.6.8-1-686
(Size: 1136kB)
Initial rootdisk image: /boot/initrd.img-2.6.8-1-686 (Size: 4540kB)
Symbolic links, unless otherwise specified, can be found in /
LILO sets up your system to boot Linux directly from your hard
disk, without the need for booting from a boot floppy.
WARNING
If you are keeping another operating system or another version
of Linux on a separate disk partition, you should not have LILO
install a boot block now. Wait until you read the LILO documentation.
That is because installing a boot block now might make the other
system un-bootable. If you only want to run this version of Linux,
go ahead and install the boot block here. If it does not work, you
can still boot this system from a boot floppy.
You already have a LILO configuration in /etc/lilo.conf
Install a boot block using the existing /etc/lilo.conf? [Yes]
Testing lilo.conf ...
An error occurred while running lilo in test mode, a log is
available in /var/log/lilo_log.17311. Please edit /etc/lilo.conf
manually and re-run lilo, or make other arrangements to boot
your machine.
Please hit return to continue