sane scanner

[Michael Gunsch <michael.gunsch@bluewin.ch>]

Hi

I don't get my usb scanner (CanoScan N656U) working under woody. Sane
1.0.12 is installed.

/var/log/messages says the following:

Apr 27 20:21:02 debian kernel: usb-uhci.c: USB UHCI at I/O 0x2020, IRQ 11
Apr 27 20:21:02 debian kernel: usb-uhci.c: Detected 2 ports
Apr 27 20:21:02 debian kernel: usb.c: new USB bus registered, assigned
bus number 1
Apr 27 20:21:02 debian kernel: hub.c: USB hub found
Apr 27 20:21:02 debian kernel: hub.c: 2 ports detected
Apr 27 20:21:02 debian kernel: usb-uhci.c: v1.275:USB Universal Host
Controller Interface driver
Apr 27 20:21:02 debian kernel: hub.c: USB new device connect on bus1/1,
assigned device number 2
Apr 27 20:21:02 debian kernel: usb.c: USB device 2 (vend/prod
0x4a9/0x2206) is not claimed by any active driver.
Apr 27 20:21:02 debian kernel: usb.c: registered new driver keyboard
Apr 27 20:21:02 debian kernel: usbkbd.c: :USB HID Boot Protocol keyboard
driver

The scanner is detected - but why does it say: "not claimed by any
active driver"?

Thanks!

Michael