[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

eth0 up, but unable to ping out

I've got my rtl8019 acknowledged and "up", but am unable to ping 
anything but lo and the local ip (

What am I doing wrong? Below are dmesg and ifconfig dumps.

dummy0    Link encap:Ethernet  HWaddr 00:00:00:00:00:00  
          inet addr:  Bcast:  
          UP BROADCAST RUNNING NOARP  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:66 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 

eth0      Link encap:Ethernet  HWaddr 52:54:40:25:16:C7  
          inet addr:  Bcast:  
          RX packets:139 errors:0 dropped:0 overruns:0 frame:0
          TX packets:66 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100 
          Interrupt:9 Base address:0x300 

lo        Link encap:Local Loopback  
          inet addr:  Mask:
          UP LOOPBACK RUNNING  MTU:3924  Metric:1
          RX packets:14 errors:0 dropped:0 overruns:0 frame:0
          TX packets:14 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 


Linux version 2.2.17 (herbert@arnor) (gcc version 2.95.2 20000313 
(Debian GNU/Linux)) #1 Sun Jun 25 09:24:41 EST 2000
Console: colour VGA+ 80x25
Calibrating delay loop... 119.60 BogoMIPS
Memory: 126920k/131072k available (1732k kernel code, 416k 
reserved, 1864k data, 140k init)
Checking if this processor honours the WP bit even in supervisor 
mode... Ok.
Dentry hash table entries: 16384 (order 5, 128k)
Buffer cache hash table entries: 131072 (order 7, 512k)
Page cache hash table entries: 32768 (order 5, 128k)
VFS: Diskquotas version dquot_6.4.0 initialized
CPU: Cyrix 6x86 2x Core/Bus Clock stepping 07
Checking 386/387 coupling... OK, FPU using exception 16 error 
Checking 'hlt' instruction... OK.
Checking for popad bug... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.35a (19990819) Richard Gooch (rgooch@atnf.csiro.au)
PCI: PCI BIOS revision 2.10 entry at 0xfdb91
PCI: Using configuration type 1
PCI: Probing PCI hardware
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
TCP: Hash tables configured (ehash 131072 bhash 65536)
Starting kswapd v 1.5 
Detected PS/2 Mouse Port.
pty: 256 Unix98 ptys configured
apm: BIOS version 1.2 Flags 0x0b (Driver version 1.13)
apm: disabled on user request.
Real Time Clock Driver v1.09
RAM disk driver initialized:  16 RAM disks of 4096K size
loop: registered device at major 7
PIIX3: IDE controller on PCI bus 00 dev 39
PIIX3: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:pio, hdb:pio
    ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:pio, hdd:pio
hda: SAMSUNG WNR-31601A (1600MB), ATA DISK drive
hdb: Conner Peripherals 1275MB - CFS1275A, ATA DISK drive
hdc: CD-ROM 48X/AKU, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: SAMSUNG WNR-31601A (1600MB), 1536MB w/256kB Cache, 
hdb: Conner Peripherals 1275MB - CFS1275A, 1219MB w/64kB Cache, 
hdc: ATAPI 48X CD-ROM drive, 128kB Cache
Uniform CD-ROM driver Revision: 3.11
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
md driver 0.36.6 MAX_MD_DEV=4, MAX_REAL=8
scsi: <fdomain> Detection failed (no card)
NCR53c406a: no available ports found
sym53c416.c: Version 1.0.0
Failed initialization of WD-7000 SCSI card!
IBM MCA SCSI: No Microchannel-bus support present -> Aborting.
megaraid: v107 (December 22, 1999)
3w-xxxx: tw_findcards(): No cards found.
scsi : 0 hosts.
scsi : detected total.
Partition check:
 hda: hda1 hda2
 hdb: hdb1
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 140k freed
NET4: Unix domain sockets 1.0 for Linux NET4.0.
Adding Swap: 302392k swap-space (priority -1)
Serial driver version 4.27 with no serial options enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
CSLIP: code copyright 1989 Regents of the University of California
PPP: version 2.3.7 (demand dialling)
PPP line discipline registered.
PPP BSD Compression module registered
ne.c:v1.10 9/23/94 Donald Becker (becker@cesdis.gsfc.nasa.gov)
NE*000 ethercard probe at 0x300: 52 54 40 25 16 c7
eth0: NE2000 found at 0x300, using IRQ 9.
VFS: Disk change detected on device fd(2,0)

Tom Schuetz  |  ts22548@cybernetisp.net


Reply to: