Re: agpgart module
On Mon, Jun 04, 2001 at 04:44:41PM -0400, Anthony Fox wrote:
> Mario Vukelic <mario.vukelic@chello.at> writes:
>
> > I still us driver 0.9.7, I don't know if there were changes for 1.0
> >
> > This is my /proc/nv/card0:
> >
> > ----- Driver Info -----
> > NVRM Version: 1.0-769
> > ------ Card Info ------
> > Model: Riva TNT1
> > IRQ: 10
> > ------ AGP Info -------
> > AGP status: Enabled
> > AGP Driver: AGPGART
> > Bridge: Ali M1541
> > SBA: Supported [disabled]
> > FW: Unsupported [disabled]
> > Rates: 2x 1x [2x]
> > Registers: 0x1b000203:0x0f000102
> >
> >
> > And this comes from my XF86Config-4:
> >
> > # From Nvidia FAQ
> > # Use this to configure AGP support. Argument is an integer:
> > # 0 : disable agp
> > # 1 : [default] use NVIDIA's internal AGP support, if possible
> > # 2 : use AGPGART, if possible
> > # 3 : use any agp support (try AGPGART, then NVIDIA's AGP)
> > Option "NvAGP" "3"
>
> Yes, this did the trick. Now I am using agp again. Thanks for your
> help.
I've tried that also, but no go:
$ cat /proc/nv/card0
----- Driver Info -----
NVRM Version: 1.0-769
------ Card Info ------
Model: Riva TNT2 Vanta
IRQ: 11
------ AGP Info -------
AGP status: Disabled
AGP Driver:
Bridge: Via MVP3
SBA: Supported [disabled]
FW: Unsupported [disabled]
Rates: 2x 1x [-]
Registers: 0x07000203:0x00000000
If I look at the logfile, I see:
(**) NVIDIA(0): Option "NvAGP" "3"
(**) NVIDIA(0): AGP is enabled
But later in the log it says:
(II) NVIDIA(0): AGP is disabled
I have also tried 'Option "NvAGP" "1" which someone recommended
earlier, but I get the same result.
I didn't try the AGPGART kernel module since I am using 2.2.17 which I
don't think had that option.
Bob
Reply to: