Re: Serial port problems
On Sunday 25 March 2001 22:27, Matthew Dalton wrote:
> Michael Dickey wrote:
> > eth0: Xircom Cardbus Adapter (DEC 21143 compatible mode) rev 3 at 0xa00,
> > 00:10:A4:E6:B8:2E, IRQ 3.
> > eth0: MII transceiver #0 config 3100 status 7809 advertising 01e1.
> > serial_attach(bus 35, fn 1)
> > tty00 at 0x0a80 (irq = 3) is a 16550A
>
> Does it work if you don't have your Xircom card inserted?
seems that it will! Before pcmcia card:
$ cat /proc/tty/driver/serial
serinfo:1.0 driver:4.27
0: uart:16550A port:3F8 irq:4 baud:9600 tx:0 rx:0
1: uart:16550A port:480 irq:3 tx:0 rx:0 CTS|DSR|CD|RI
2: uart:unknown port:3E8 irq:4
3: uart:unknown port:2E8 irq:3
After inserting card:
$ cat /proc/tty/driver/serial
serinfo:1.0 driver:4.27
0: uart:16550A port:A80 irq:3 baud:9600 tx:0 rx:0 CTS|DSR
1: uart:unknown port:2F8 irq:3
2: uart:unknown port:3E8 irq:4
3: uart:unknown port:2E8 irq:3
4: uart:unknown port:3220 irq:3
5: uart:unknown port:3228 irq:3
6: uart:unknown port:4220 irq:3
7: uart:unknown port:4228 irq:3
8: uart:unknown port:5220 irq:3
9: uart:unknown port:5228 irq:3
> > eth0: Promiscuous mode enabled.
> > device eth0 entered promiscuous mode
>
> This worries me. Why is your network card going into promiscuous mode?
I have to do this to make the card work - done on purpose...
Michael
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
Reply to: