Re: CD-RW mount errors
On Mon, Mar 01, 1999 at 12:05:26PM -0800, Paul Nathan Puri wrote:
> Here is my dmesg output:
>
> Linux version 2.2.2 (root@office) (gcc version 2.7.2.3) #50 Sun Feb 28
> 19:42:41
> PST 1999
> Detected 266618583 Hz processor.
> Console: colour VGA+ 80x25
> Calibrating delay loop... 266.24 BogoMIPS
> Memory: 387708k/393216k available (968k kernel code, 408k reserved, 4072k
> data,
> 60k init)
[snip]
> PIIX4: IDE controller on PCI bus 00 dev 39
> PIIX4: not 100% native mode: will probe irqs later
> ide0: BM-DMA at 0xfc90-0xfc97, BIOS settings: hda:DMA, hdb:pio
> ide1: BM-DMA at 0xfc98-0xfc9f, BIOS settings: hdc:DMA, hdd:DMA
> hda: Maxtor 86480D6, ATA DISK drive
> hdc: NEC CD-ROM DRIVE:28B, ATAPI CDROM drive
> hdd: no response (status = 0xd0), resetting drive
^^^^^^^^^
This is not good...
> hdd: HP CD-Writer+ 7200, ATAPI CDROM drive
> ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> ide1 at 0x170-0x177,0x376 on irq 15
> hda: Maxtor 86480D6, 6149MB w/256kB Cache, CHS=784/255/63, UDMA
> Floppy drive(s): fd0 is 1.44M
> FDC 0 is a National Semiconductor PC87306
> scsi0 : SCSI host adapter emulation for IDE ATAPI devices
> scsi : 1 host.
> Vendor: NEC Model: CD-ROM DRIVE:28B Rev: 3.05
> Type: CD-ROM ANSI SCSI revision: 02
> Vendor: HP Model: CD-Writer+ 7200 Rev: 3.01
> Type: CD-ROM ANSI SCSI revision: 02
> scsi : detected total.
Well, I think it supposed to say:
scsi : detected 2 SCSI cdrom total.
I also have line:
Uniform CDROM driver Revision: 2.52
Would you post your /usr/src/linux/.config?
> PPP: version 2.3.3 (demand dialling)
> TCP compression code copyright 1989 Regents of the University of
> California
> PPP line discipline registered.
> tulip.c:v0.89H 5/23/98 becker@cesdis.gsfc.nasa.gov
> eth0: Lite-On 82c168 PNIC at 0xf800, 00 a0 cc 3b f6 96, IRQ 9.
> eth0: MII transceiver found at MDIO address 1, config 1000 status 782d.
> eth0: Advertising 01e1 on PHY 1, previously advertising 01e1.
> Partition check:
> hda: hda1 hda2 hda3 hda4
> VFS: Mounted root (ext2 filesystem) readonly.
> Freeing unused kernel memory: 60k freed
> Adding Swap: 130748k swap-space (priority -1)
> SoftOSS driver Copyright (C) by Hannu Savolainen 1993-1997
> TIOCSER?WILD ioctl obsolete, ignored.
> TIOCSER?WILD ioctl obsolete, ignored.
> eth0: Changing PNIC configuration to half-duplex, CSR6 812e0000.
> registered device ppp0
> PPP BSD Compression module registered
> PPP Deflate Compression module registered
> VFS: Disk change detected on device ide1(22,0)
> ide-scsi: hdc: unsupported command in request queue (0)
> end_request: I/O error, dev 16:00 (hdc), sector 64
> isofs_read_super: bread failed, dev=16:00, iso_blknum=16, block=32
>
Reply to: