Re: Help!! Getting LILO working?

[Andrew Ivanov <c680789@showme.missouri.edu>]

Ok, here is hwo you should do it:

boot = /dev/hda   #Disk to boot (Master on primary IDE)
root = /dev/hdb2     #Where root partition is
install = /boot/boot.b
map = /boot/map
vga = normal
delay = 50
prompt
ramdisk = 0

read-only
default = linux

image = /vmlinuz    #Linux kernel
label = Debian
alias = linux

image = /boot/vmlinbackup  #This is a backup kernel. If you don't have 
label = backup             #One, comment those lines out

other = /dev/hda1           #This is a Windows partition
label = MS
table = /dev/hda



just put that into /etc/lilo.conf
and run 
lilo
It should give no warnings. Then reboot, and linux will load on default.
Andrew
____________________________________________________________________
Never include a comment that will help | Andrew Ivanov
someone else understand your code.     | c680789@showme.missouri.edu
If they understand it, they don't      | ICQ: 12402354
need you.                              |