scsi newbie
I have an Adaptec adapter with an internal CDRW and IOMEGA Zip
on the external 68-pin connector. On bootup my kernel seems to "see"
the devices but does not report back mountable points (ie sda, sdb4).
I have appended the relevant dmesg section, thanks for your time.
[clip]
hda: QUANTUM FIREBALL ST2.1A, 2014MB w/81kB Cache, CHS=1023/64/63, DMA
hdb: , ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
aic7xxx: Warning - detected auto-termination on controller:
aic7xxx: <Adaptec AHA-294X Ultra SCSI host adapter> at PCI 9/0
aic7xxx: Please verify driver detected settings are correct.
aic7xxx: If not, then please properly set the device termination
aic7xxx: in the Adaptec SCSI BIOS by hitting CTRL-A when prompted
aic7xxx: during machine bootup.
aic7xxx: Cables present (Int-50 YES, Int-68 NO, Ext-68 NO)
aic7xxx: Termination (Low ON, High ON)
(scsi0) <Adaptec AHA-294X Ultra SCSI host adapter> found at PCI 9/0
(scsi0) Wide Channel, SCSI ID=7, 16/255 SCBs
(scsi0) BIOS enabled, IO Port 0x7c00, IRQ 12
(scsi0) IO Memory at 0xffafb000, MMAP Memory at 0x4819000
(scsi0) Resetting channel
(scsi0) Downloading sequencer code... 406 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.0.14/3.2.4
<Adaptec AHA-294X Ultra SCSI host adapter>
scsi : 1 host.
(scsi0:0:-1:-1) Scanning channel for devices.
(scsi0:0:3:0) Refusing WIDE negotiation; using 8 bit transfers.
(scsi0:0:3:0) Refusing synchronous negotiation; using asynchronous
transfers.
Vendor: YAMAHA Model: CRW4260 Rev: 1.0h
Type: CD-ROM ANSI SCSI revision: 02
(scsi0:0:6:0) Refusing WIDE negotiation; using 8 bit transfers.
(scsi0:0:6:0) Refusing synchronous negotiation; using asynchronous
transfers.
Vendor: IOMEGA Model: ZIP 100 Rev: J.02
Type: Direct-Access ANSI SCSI revision: 02
scsi : detected total.
Partition check:
hda: hda1 hda2 hda3
VFS: Mounted root (ext2 filesystem) readonly.
[/clip]
Reply to: