Re: LILO, yet again
Do you have a large disk? If so, get into your cmos setup (just before
bootup) and change that disk to type LBA and see it that fixes it.
On Fri, 22 Aug 1997, Paul Lange wrote:
> Thank you, Mr. Schmitz. You fixed that problem for me. Unfortunately, now,
> when it boots, it stops at LI. Sigh. The docs say this means that the second
> stage loader failed to be executed by the first stage loader, and that is
> probably due to a geometry mismatch or move of /boot/boot.b without running the
> map installer. However, none of these occurred. And I double checked by
> running lilo again.
>
> Incidentally, I'm sure this has already come up here, but since I upgraded to
> 1.3, some of my modules don't load in the initial startup and give some sort
> of "not found" error message, but load up fine by hand later on.
> --
> Paul Lange
> University of Texas ECE LRC Unix Services
> internet: pel@mail.utexas.edu
> web: http://www.ece.utexas.edu/~pel
>
>
> --
> TO UNSUBSCRIBE FROM THIS MAILING LIST: e-mail the word "unsubscribe" to
> debian-user-request@lists.debian.org .
> Trouble? e-mail to templin@bucknell.edu .
>
>
George Bonser
Debian/GNU Linux See http://www.debian.org
Linux ... It isn't just for breakfast anymore!
--
TO UNSUBSCRIBE FROM THIS MAILING LIST: e-mail the word "unsubscribe" to
debian-user-request@lists.debian.org .
Trouble? e-mail to templin@bucknell.edu .
Reply to: