Re: ATI Radeon 9700
> Hast du die XF86Config-4 für den fglrx Treiber entsprechend
> eingerichtet? Was sagt die Log-Datei des X-Servers?
Ach so, die XFree86.0.log liefer:
...
(II) LoadModule: "fglrx"
(II) Loading /usr/X11R6/lib/modules/drivers/fglrx_drv.o
(II) Module fglrx: vendor="FireGL - ATI Technologies Inc."
compiled for 4.3.0.1, module version = 8.10.19
Module class: XFree86 Video Driver
ABI class: XFree86 Video Driver, version 0.6
...
(--) Chipset MOBILITY RADEON 9600/9700 (M10/M11 4E50) found
(II) fglrx(0): initializing int10
(II) fglrx(0): Primary V_BIOS segment is: 0xc000
(--) fglrx(0): Chipset: "MOBILITY RADEON 9600/9700 (M10/M11 4E50)" (Chipset = 0x4e50)
(--) fglrx(0): (PciSubVendor = 0x1179, PciSubDevice = 0xff02)
(--) fglrx(0): board vendor info: third party grafics adapter - NOT original ATI
(--) fglrx(0): Linear framebuffer (phys) at 0xd8000000
(--) fglrx(0): MMIO registers at 0xd0100000
(--) fglrx(0): ChipExtRevID = 0x00
(--) fglrx(0): ChipIntRevID = 0x0C
(--) fglrx(0): VideoRAM: 65536 kByte (64-bit SDR SDRAM)
(WW) fglrx(0): board is an unknown third party board, chipset is supported
(II) fglrx(0): I2C bus "DDC" initialized.
(II) fglrx(0): Connector Layout from BIOS --------
(II) fglrx(0): Connector1: DDCType-3, DACType-0, TMDSType--1, ConnectorType-2
(II) fglrx(0): I2C device "DDC:ddc2" registered at address 0xA0.
(II) fglrx(0): I2C device "DDC:ddc2" removed.
(II) fglrx(0): I2C device "DDC:ddc2" registered at address 0xA0.
(II) fglrx(0): I2C device "DDC:ddc2" removed.
(II) fglrx(0): I2C device "DDC:ddc2" registered at address 0xA0.
(II) fglrx(0): I2C device "DDC:ddc2" removed.
(II) fglrx(0): DDC detected on DDCType 3 with Monitor Type 0
(II) fglrx(0): Primary head:
Monitor -- LVDS
Connector -- None
DAC Type -- Unknown
TMDS Type -- NONE
DDC Type -- NONE
(II) fglrx(0): Secondary head:
Monitor -- NONE
(II) fglrx(0): Secondary head:
Monitor -- NONE
Connector -- VGA
DAC Type -- Primary
TMDS Type -- NONE
DDC Type -- VGA_DDC
(II) fglrx(0):
(II) fglrx(0): DesktopSetup 0x0000
(II) fglrx(0): Panel ID string: CPT
(II) fglrx(0): Panel Size from BIOS: 1024x768
(==) fglrx(0): PseudoColor visuals disabled
(==) fglrx(0): Overlay disabled
(**) fglrx(0): Overlay disabled
(II) fglrx(0): PLL parameters: rf=2700 rd=6 min=20000 max=35000
(==) fglrx(0): Using gamma correction (1.0, 1.0, 1.0)
(==) fglrx(0): Center Mode is disabled
(==) fglrx(0): TMDS coherent mode is enabled
(II) fglrx(0): Valid mode using on-chip RMX: 1024x768
(II) fglrx(0): Valid mode using on-chip RMX: 800x600
(II) fglrx(0): Valid mode using on-chip RMX: 640x480
(II) fglrx(0): Total 3 valid mode(s) found.
(--) fglrx(0): Virtual size is 1024x768 (pitch 1024)
(**) fglrx(0): *Mode "1024x768": 65.0 MHz (scaled from 0.0 MHz), 49.2 kHz, 61.3 Hz
(II) fglrx(0): Modeline "1024x768" 65.00 1024 1048 1184 1320 768 771 777 803
(**) fglrx(0): *Mode "800x600": 65.0 MHz (scaled from 0.0 MHz), 49.2 kHz, 61.3 Hz
(II) fglrx(0): Modeline "800x600" 65.00 800 1048 1184 1320 600 771 777 803
(**) fglrx(0): *Mode "640x480": 65.0 MHz (scaled from 0.0 MHz), 49.2 kHz, 61.3 Hz
(II) fglrx(0): Modeline "640x480" 65.00 640 1048 1184 1320 480 771 777 803
(==) fglrx(0): DPI set to (75, 75)
(==) fglrx(0): NoAccel = NO
(==) fglrx(0): HPV inactive
(==) fglrx(0): FSAA enabled: NO
(==) fglrx(0): FSAA Gamma enabled
(==) fglrx(0): FSAA Multisample Position is fix
(==) fglrx(0): NoDRI = NO
(II) Loading sub module "fglrxdrm"
(II) LoadModule: "fglrxdrm"
(II) Loading /usr/X11R6/lib/modules/linux/libfglrxdrm.a
(II) Module fglrxdrm: vendor="FireGL - ATI Technologies Inc."
compiled for 4.3.0.1, module version = 8.10.19
ABI class: XFree86 Server Extension, version 0.2
(II) fglrx(0): Depth moves disabled by default
(==) fglrx(0): Capabilities: 0x00000000
(==) fglrx(0): cpuFlags: 0x8000001d
(==) fglrx(0): cpuSpeedMHz: 0x0000063e
(==) fglrx(0): OpenGL ClientDriverName: "fglrx_dri.so"
(**) fglrx(0): using built in AGPGART module: yes
(==) fglrx(0): UseFastTLS=0
(==) fglrx(0): BlockSignalsOnLock=1
(==) fglrx(0): EnablePrivateBackZ = NO
(II) fglrx(0): UMM area: 0xd8501000 (size=0x03aff000)
(II) fglrx(0): driver needs XFree86 version: 4.3.x
(II) fglrx(0): detected XFree86 version: 4.3.0
(II) Loading extension ATIFGLRXDRI
(II) fglrx(0): doing DRIScreenInit
drmOpenDevice: minor is 0
drmOpenDevice: node name is /dev/dri/card0
drmOpenDevice: open result is 5, (OK)
drmOpenDevice: minor is 0
drmOpenDevice: node name is /dev/dri/card0
drmOpenDevice: open result is 5, (OK)
drmOpenDevice: minor is 0
drmOpenDevice: node name is /dev/dri/card0
drmOpenDevice: open result is 5, (OK)
drmGetBusid returned ''
(II) fglrx(0): [drm] created "fglrx" driver at busid "PCI:1:0:0"
(II) fglrx(0): [drm] added 8192 byte SAREA at 0xe090d000
(II) fglrx(0): [drm] mapped SAREA 0xe090d000 to 0xb7db0000
(II) fglrx(0): [drm] framebuffer handle = 0xd8000000
(II) fglrx(0): [drm] added 1 reserved context for kernel
(II) fglrx(0): DRIScreenInit done
(II) fglrx(0): Kernel Module Version Information:
(II) fglrx(0): Name: fglrx
(II) fglrx(0): Version: 8.10.19
(II) fglrx(0): Date: Feb 9 2005
(II) fglrx(0): Desc: ATI FireGL DRM kernel module
(II) fglrx(0): Kernel Module version matches driver.
(II) fglrx(0): Kernel Module Build Time Information:
(II) fglrx(0): Build-Kernel UTS_RELEASE: 2.6.10
(II) fglrx(0): Build-Kernel MODVERSIONS: no
(II) fglrx(0): Build-Kernel __SMP__: no
(II) fglrx(0): Build-Kernel PAGE_SIZE: 0x1000
(II) fglrx(0): [drm] register handle = 0xd0100000
(II) fglrx(0): [agp] Mode=0x1f000217 bridge: 0x8086/0x3580
(II) fglrx(0): [agp] AGP v1/2 disable mask 0x00000000
(II) fglrx(0): [agp] AGP v3 disable mask 0x00000000
(II) fglrx(0): [agp] enabling AGP with mode=0x1f000314
(II) fglrx(0): [agp] AGP protocoll is enabled for grafics board. (cmd=0x1f000314)
(II) fglrx(0): [agp] grafics chipset has AGP v2.0
(II) fglrx(0): [drm] ringbuffer size = 0x00100000 bytes
(II) fglrx(0): [drm] DRM buffer queue setup: nbufs = 100 bufsize = 28672
(II) fglrx(0): [drm] texture shared area handle = 0xe4c01000
(II) fglrx(0): shared FSAAScale=1
(II) fglrx(0): DRI initialization successfull!
(II) fglrx(0): FBADPhys: 0xd8000000 FBMappedSize: 0x00501000
(II) fglrx(0): Splitting WC range: base: 0xd8000000, size: 0x501000
(II) fglrx(0): Splitting WC range: base: 0xd8400000, size: 0x101000
(==) fglrx(0): Write-combining range (0xd8500000,0x1000)
(==) fglrx(0): Write-combining range (0xd8400000,0x101000)
(==) fglrx(0): Write-combining range (0xd8000000,0x501000)
(II) fglrx(0): FBMM initialized for area (0,0)-(1024,1281)
(II) fglrx(0): FBMM auto alloc for area (0,0)-(1024,768) (front color buffer - assumption)
(==) fglrx(0): Backing store disabled
(==) fglrx(0): Silken mouse enabled
(II) fglrx(0): Using hardware cursor (scanline 768)
(II) fglrx(0): Largest offscreen area available: 1024 x 505
(II) fglrx(0): Largest offscreen area available: 1024 x 505
(**) Option "dpms"
(**) fglrx(0): DPMS enabled
(II) fglrx(0): Using XFree86 Acceleration Architecture (XAA)
Screen to screen bit blits
Solid filled rectangles
8x8 mono pattern filled rectangles
Solid Lines
Dashed Lines
Offscreen Pixmaps
Setting up tile and stipple cache:
24 128x128 slots
(II) fglrx(0): Acceleration enabled
(II) fglrx(0): X context handle = 0x00000001
(II) fglrx(0): [DRI] installation complete
(II) fglrx(0): Direct rendering enabled
(**) fglrx(0): Video overlay enabled on CRTC1
(II) Loading extension FGLRXEXTENSION
(II) Loading extension ATITVOUT
(==) RandR enabled
(II) Setting vga for screen 0.
(II) Initializing built-in extension MIT-SHM
(II) Initializing built-in extension XInputExtension
(II) Initializing built-in extension XTEST
(II) Initializing built-in extension XKEYBOARD
(II) Initializing built-in extension LBX
(II) Initializing built-in extension XC-APPGROUP
(II) Initializing built-in extension SECURITY
(II) Initializing built-in extension XINERAMA
(II) Initializing built-in extension XFree86-Bigfont
(II) Initializing built-in extension RENDER
(II) Initializing built-in extension RANDR
Dem logfile nach, scheint das Modul ja geladen zu werden.
>
> MfG Daniel
Gruß
Christian
Reply to: