USB-Platte mounten
Hi, Liste ...
... folgendes Problem:
Ich habe mehrere USB-Festplatten, die ich betreiben will. Mit dem alten
2.4.er-Kernel (und murasaki, usb-storage und hotplug) kein Problem. Mit
dem 2.6.er-Kernel (und den gleichen - zum Teil nachkompilierten -
Paketen) keine Erkennung, bzw. Linux erkennt zwar, das was am USB-Port
hängt, aber nicht was. im 2.4.er wurde mir die Platte ordnungsgemäß mit
Hersteller etc. angezeigt Und liess sich mit /dev/sda /mnt/wechselplatte
mounten.
---------------------------------------------------
dmesg sagt:
...
scsi1 : SCSI emulation for USB Mass Storage devices
Vendor: SAMSUNG Model: SP1604N Rev: TM10
Type: Direct-Access ANSI SCSI revision: 02
SCSI device sda: 312581809 512-byte hdwr sectors (160042 MB)
sda: assuming drive cache: write through
/dev/scsi/host1/bus0/target0/lun0: p1
Attached scsi disk sda at scsi1, channel 0, id 0, lun 0
USB Mass Storage device found at 3
NTFS driver 2.1.14 [Flags: R/O MODULE].
FAT: invalid media value (0xb9)
VFS: Can't find a valid FAT filesystem on dev sda.
NTFS-fs error (device sda): read_ntfs_boot_sector(): Primary boot sector
is invalid.
NTFS-fs error (device sda): read_ntfs_boot_sector(): Mount option
errors=recover not used. Aborting without trying to recover.
NTFS-fs error (device sda): ntfs_fill_super(): Not an NTFS volume.
FAT: invalid media value (0xb9)
VFS: Can't find a valid FAT filesystem on dev sda.
FAT: invalid media value (0xb9)
VFS: Can't find a valid FAT filesystem on dev sda.
FAT: invalid media value (0xb9)
VFS: Can't find a valid FAT filesystem on dev sda.
FAT: invalid media value (0xb9)
VFS: Can't find a valid FAT filesystem on dev sda.
FAT: invalid media value (0xb9)
VFS: Can't find a valid FAT filesystem on dev sda.
NTFS-fs error (device sda): read_ntfs_boot_sector(): Primary boot sector
is invalid.
NTFS-fs error (device sda): read_ntfs_boot_sector(): Mount option
errors=recover not used. Aborting without trying to recover.
NTFS-fs error (device sda): ntfs_fill_super(): Not an NTFS volume.
FAT: invalid media value (0xb9)
VFS: Can't find a valid FAT filesystem on dev sda.
usb 1-2: USB disconnect, address 3
usb 1-2: new high speed USB device using address 4
scsi2 : SCSI emulation for USB Mass Storage devices
Vendor: SAMSUNG Model: SP1604N Rev: TM10
Type: Direct-Access ANSI SCSI revision: 02
SCSI device sda: 312581809 512-byte hdwr sectors (160042 MB)
sda: assuming drive cache: write through
/dev/scsi/host2/bus0/target0/lun0: p1
Attached scsi disk sda at scsi2, channel 0, id 0, lun 0
USB Mass Storage device found at 4
athene:~#
---------------------------------------
wo liegt das Problem?
MfG
Stefan
Reply to: