Re: DWL G122
- ural defines an eth* device, not a wlan*
- check that the device is recognized using dmesg. You should have
something like
usb 4-1: new high speed USB device using ehci_hcd and address 6
ural_eeprom_read: 4 -> 00:11:d8:42:49:8c
eth1: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
eth1: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps
24Mbps 36Mbps 48Mbps 54Mbps
eth1: RT2570 (rev 0x03), RF RT2526, ether 00:11:d8:42:49:8c at
usb-0001:10:1b.2-1
ural_set_macaddr: 00:11:d8:42:49:8c
setting MAC address to 00:11:d8:42:49:8c
leaving promiscuous mode
- check that you compiled the wireless extensions in your kernel. It is
in Device Drivers/Networking Support/Wireless LAN
I don't think you need any special USB drivers as ural takes care of
everything
Sylvain
Reply to:
- References:
- DWL G122
- From: Andrea Lusuardi - UoVoBW <linolusu@tin.it>
- Re: DWL G122
- From: Sylvain Joyeux <sylvain.joyeux@m4x.org>
- Re: DWL G122
- From: Andrea Lusuardi - UoVoBW <linolusu@tin.it>