PSION 56k + 10/100 PCMCIA-card (cardbus)

[Jan Braun <Rektorassistent@tu-clausthal.de>]

Good evening again,

I got a	Psion Gold Card Netglobal 56K+10/100Mb cardbus card and try to
run it an an ACER Travelmate 212 TX.

The kernel is capcable of pcmcia-cards.  It is even capable of this
card, but I didn't manage to configure this card automatically :-(  I
tried instead a different PCMCIA ethernet card with success.

When inserting the card into the cardbus slot, the cardmgr does not
allways beep, but if it does, the following could be read in
/var/log/messages:

   kernel: cs: cb_alloc(bus 2): vendor 0x10b8, device 0x006
   kernel: PCI Enabling device 02:00.0 (0000 -> 0003)
   kernel: PCI Enabling device 02:00.1 (0000 -> 0003)
   kernel: Redundant entry in serial pci_table. Please send ...
   kernel: register_serial(): failed

The output of syslog was truncated.

The configuration of this card stops at this message.  If I insert the
compiled epic100.o module into the kernel by hand, the ethernet-part
of this card is configured properly.

What is my fault?  What is going wrong?

Thanks in advanve.

Bye

        Jan