Re: Lilo Help
Russell Coker wrote:
boot=/dev/hda5
change to boot=/dev/hda
fixed the problem......
Now it's on to X using XFree.....
Thanks for the pointer to the doc... as I'm new to Debian
>
> On Mon, 9 Sep 2002 21:25, Designer wrote:
> > I ran " lilo" after that. It looked ok, but I still get the
> >
> > L01 01 01 01
> >
> > repeating (01) moniker....
>
> >From /usr/share/doc/lilo/Manual.txt.gz:
>
> L <error> ... The first stage boot loader has been loaded and started,
> but it can't load the second stage boot loader. The two-digit error
> codes indicate the type of problem. (See also section "Disk error
> codes".) This condition usually indicates a media failure or a geometry
> mismatch (e.g. bad disk parameters, see section "Disk geometry").
>
> [...]
> Disk error codes
> - - - - - - - -
>
> If the BIOS signals an error when LILO is trying to load a boot image, the
> respective error code is displayed. The following BIOS error codes are
> known:
>
> [...]
> 0x01 "Illegal command". This shouldn't happen, but if it does, it may
> indicate an attempt to access a disk which is not supported by the
> BIOS. See also "Warning: BIOS drive 0x<number> may not be accessible"
> in section "Warnings".
>
> --
> I do not get viruses because I do not use MS software.
> If you use Outlook then please do not put my email address in your
> address-book so that WHEN you get a virus it won't use my address in the
> >From field.
>
> --
> To UNSUBSCRIBE, email to debian-laptop-request@lists.debian.org
> with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Reply to: