Re: 2.4.18 kernel hang using Symbios driver
----- Original Message -----
From: "Jay Estabrook" <Jay.Estabrook@compaq.com>
Subject: Re: 2.4.18 kernel hang using Symbios driver
> On Wed, May 01, 2002 at 04:07:19PM +1000, Rob Byrnes wrote:
> >
> > Has anyone else had problems booting a 2.4.18 kernel with the SYM53C8XX
> > driver?
> >
> > I have a Cabriolet running Woody, and while kernel 2.2.20 with the same
the
> > driver loads up fine, I get SCSI RESET error messages and then a hang
while
> > trying to boot into 2.4.18. The SCSI card is a Tekram DC 390U.
> >
> > I have also tried the "generic" NCR53C8XX driver with identical results.
>
> Any chance you could provide us with the bootlog of the failure?
>
> Many things have changed between 2.2.20 and 2.4.18, and a log may give
> us some hints as to what might have gone wrong...
Well, here is what comes up on the screen during boot:
<snip>
SCSI subsystem driver Revision: 1.00
sym.0.5.0: setting PCI_COMMAND_INVALIDATE.
sym0: <875> rev 0x1 on pci bus 0 device 5 function 0 irq 23
sym0: Tekram NVRAM, ID 7, Fast-20, SE, parity checking
sym0: SCSI bus has been reset.
scsi0 : sym-2.1.17a
sym0:0:0: ABORT operation started.
sym0:0:0: ABORT operation timed out.
sym0:0:0: DEVICE RESET operation started.
sym0:0:0: DEVICE RESET operation timed out.
sym0:0:0: BUS RESET operation started.
sym0:0:0: BUS RESET operation timed out.
sym0:0:0: HOST RESET operation started.
sym0: SCSI bus has been reset
The boot sequence hangs at this point. I don't know why the bus is being
reset either.
Cheers,
Rob
--
To UNSUBSCRIBE, email to debian-alpha-request@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Reply to: