Re: need help on setup netgear adapter
Thank Andy! i've just installed bullseye again, and can't get it to work with netgear wn111. its problem is same as fresh install of buster. actually i've complained this before: if wifi adapter isn't set up by installer, then i'm unable to get it to work after installation
i always use same procedure to get connected: edit /etc/network/interfaces, then run ifup/ifdown to take effect, i'm not aware of network manager
allow-hotplug wlxe091f5061648
iface wlxe091f5061648 inet dhcp
wpa-ssid mice
wpa-key-mgmt NONE
my old bullseye works, ifup looks like this:
Internet Systems Consortium DHCP Client 4.4.1
Copyright 2004-2018 Internet Systems Consortium.
All rights reserved.
For info, please visit https://www.isc.org/software/dhcp/
Listening on LPF/wlxe091f5061648/e0:91:f5:06:16:48
Sending on LPF/wlxe091f5061648/e0:91:f5:06:16:48
Sending on Socket/fallback
DHCPDISCOVER on wlxe091f5061648 to 255.255.255.255 port 67 interval 5
DHCPDISCOVER on wlxe091f5061648 to 255.255.255.255 port 67 interval 5
DHCPOFFER of 192.168.41.52 from 192.168.41.1
DHCPREQUEST for 192.168.41.52 on wlxe091f5061648 to 255.255.255.255 port 67
DHCPACK of 192.168.41.52 from 192.168.41.1
bound to 192.168.41.52 -- renewal in 676 seconds.
Reply to: