Debian 10.4 blank screen After new install

[echo test <echotest09@gmail.com>]

Hello,

That blank screen means your hardware has not found the way to load your boot partition. Verify your BIOS configuration. Try toggling between UEFI and MBR assuming your bootable device is ok. 

Le mer. 22 juil. 2020 à 05:20, Edward M Kent <mick2kent@gmail.com> a écrit :

Hello All,   I am an old Nube trying to get set up to use a Beaglebone on some projects.  I thought I had a successful install after a list of tasks was displayed down the screen's left hand edge.  The list went blank and left a - in the upper left corner.  This curser soon disappeared leaving a blank screen.  The mouse cursed did show up but was a bit erratic.  I rebooted several times and ended back at the same place.

This is on a win10 Dell and I can not get back to win10 because I did not get the dual boot setup.

Thanks for any advice.

Mick