Re: Laptop wireless problem
On Sunday 03 July 2016 10:25:55 deloptes wrote:
> now what I don't understand is can you use your intel/build in.
No. That was the original problem and why I was trying to use an external card
in the first place.
> you also
> did not post the intel dmesg firmware loading lines, but i assume if you
> see networks it would be fine.
Sorry. I was beginning to have difficulty seeing what I had posted. I
thought that I had posted both. I certainly grepped for both.
root@debian-wheezy:/home/sarah# dmesg | grep 2200
[ 10.873432] ipw2200: Intel(R) PRO/Wireless 2200/2915 Network Driver,
1.2.2kmprq
[ 10.873438] ipw2200: Copyright(c) 2003-2006 Intel Corporation
[ 10.873683] ipw2200: Detected Intel PRO/Wireless 2200BG Network Connection
[ 10.970011] ipw2200 0000:03:03.0: firmware: direct-loading firmware
ipw2200-bss.fw
[ 11.214232] ipw2200: Detected geography ZZD (13 802.11bg channels, 0
802.11a channels)
root@debian-wheezy:/home/sarah#
This is the current state:
root@debian-wheezy:/home/sarah# ifconfig
eth0 Link encap:Ethernet HWaddr 00:14:22:e7:6f:21
inet addr:192.168.0.9 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::214:22ff:fee7:6f21/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:409 errors:0 dropped:0 overruns:0 frame:0
TX packets:234 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:68628 (67.0 KiB) TX bytes:29511 (28.8 KiB)
Interrupt:18
eth1 Link encap:Ethernet HWaddr 00:16:6f:00:3a:b3
inet6 addr: fe80::216:6fff:fe00:3ab3/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:55 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:9434 (9.2 KiB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:85 errors:0 dropped:0 overruns:0 frame:0
TX packets:85 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:22633 (22.1 KiB) TX bytes:22633 (22.1 KiB)
root@debian-wheezy:/home/sarah#
> to use networkmanager or wicd remove all the configs from your /etc/network
> whatever files. perhaps double check with the upgrade howto and the docs
> for the manager.
Yes - that is the same for Ethernet, and I am much more used to, and therefore
much less incompetent at, Ethernet than wlan.
I have just checked. It is not working. I suspect that none of the GUI
software, this being an old 32 bit laptop, can handle IPv6. But it seems
very odd that the card is finding the networks (and it is finding quite a
few) and getting an IPv6 address, but not getting an IPv4 one.
Might it be a hardware problem? Which is where trying another card came
in. ;-) I would rather get the original card going - and overnight thought
of trying to buy a replacement. I had been forgetting, until you told me to
look at the BIOS, that that vintage has a mini-PCI card, not onboard
wireless. It could easily be changed if I could get a replacement. It is
even pretty accessible!!
Thanks,
Lisi
Reply to: