Intel N-130 wireless does not work on Weezy
I just installed Weezy on an MSI GT780DXR laptop dual-booting with MS-Windows.
Networking works through an Ethernet cable to the DSL router, but not
the wireless,
even though I've installed the drivers from the
http://intellinuxwireless.org/ site.
This is the relevant part of the output of lspci -vv:
03:00.0 Network controller: Intel Corporation Centrino Wireless-N 130 (rev 34)
Subsystem: Intel Corporation Centrino Wireless-N 130 BGN
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 64 bytes
Interrupt: pin A routed to IRQ 54
Region 0: Memory at f6200000 (64-bit, non-prefetchable) [size=8K]
Capabilities: [c8] Power Management version 3
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA
PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [d0] MSI: Enable+ Count=1/1 Maskable- 64bit+
Address: 00000000feeff00c Data: 41c9
Capabilities: [e0] Express (v1) Endpoint, MSI 00
DevCap: MaxPayload 128 bytes, PhantFunc 0, Latency L0s
<512ns, L1 unlimited
ExtTag- AttnBtn- AttnInd- PwrInd- RBE+ FLReset+
DevCtl: Report errors: Correctable- Non-Fatal- Fatal-
Unsupported-
RlxdOrd- ExtTag- PhantFunc- AuxPwr- NoSnoop+ FLReset-
MaxPayload 128 bytes, MaxReadReq 128 bytes
DevSta: CorrErr- UncorrErr- FatalErr- UnsuppReq-
AuxPwr+ TransPend-
LnkCap: Port #0, Speed 2.5GT/s, Width x1, ASPM L0s L1,
Latency L0 <4us, L1 <32us
ClockPM+ Surprise- LLActRep- BwNot-
LnkCtl: ASPM Disabled; RCB 64 bytes Disabled- Retrain- CommClk+
ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt-
LnkSta: Speed 2.5GT/s, Width x1, TrErr- Train-
SlotClk+ DLActive- BWMgmt- ABWMgmt-
Capabilities: [100 v1] Advanced Error Reporting
UESta: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt-
UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-
UEMsk: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt-
UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-
UESvrt: DLP+ SDES- TLP- FCP+ CmpltTO- CmpltAbrt-
UnxCmplt- RxOF+ MalfTLP+ ECRC- UnsupReq- ACSViol-
CESta: RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr-
CEMsk: RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr+
AERCap: First Error Pointer: 00, GenCap- CGenEn- ChkCap- ChkEn-
Capabilities: [140 v1] Device Serial Number b8-03-05-ff-ff-0e-c7-b1
Kernel driver in use: iwlwifi
And this is from dmesg:
[ 18.202367] iwlwifi 0000:03:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18
[ 18.202377] iwlwifi 0000:03:00.0: setting latency timer to 64
[ 18.202398] iwlwifi 0000:03:00.0: pci_resource_len = 0x00002000
[ 18.202400] iwlwifi 0000:03:00.0: pci_resource_base = ffffc900065d8000
[ 18.202402] iwlwifi 0000:03:00.0: HW Revision ID = 0x34
[ 18.202488] iwlwifi 0000:03:00.0: irq 54 for MSI/MSI-X
[ 18.202522] iwlwifi 0000:03:00.0: Detected Intel(R) Centrino(R)
Wireless-N 130 BGN, REV=0xB0
[ 18.202585] iwlwifi 0000:03:00.0: L1 Disabled; Enabling L0S
[ 18.219015] iwlwifi 0000:03:00.0: device EEPROM VER=0x716, CALIB=0x6
[ 18.219017] iwlwifi 0000:03:00.0: Device SKU: 0X150
[ 18.219019] iwlwifi 0000:03:00.0: Valid Tx ant: 0X1, Valid Rx ant: 0X3
[ 18.219052] iwlwifi 0000:03:00.0: Tunable channels: 13 802.11bg, 0
802.11a channels
[ 18.660790] iwlwifi 0000:03:00.0: loaded firmware version
17.168.5.1 build 33993
What else could I do to fix this? Thanks!
Al
Reply to: