On Mon, 03 Oct 2011 10:40:24 +0800, lina wrote:
On Sun, Oct 2, 2011 at 11:05 PM, Camaleón<noelamac@gmail.com> wrote:
(...)
Determine where is the disk/partition and then mount it -first attempt-
as usual, i.e. (do not copy/paste, adjust it to your needs):
mount /dev/sdb1 /mnt
Thanks. it works.
Good :-)
just a little question here,
I only have 2 partitions in hard drive, why there are 6 sdb which ranges
from sdb1 to sdb6.
Dunno... attach the drive and give us the output of (as root):
fdisk -l /dev/sdb
I even don't know which two exactly are the true one, so tried one by
one.
are there some way to identify each? sdb.
Yes, you can "label" partitions to identify them :-)
Look:
stt008:~# blkid|grep sdc
/dev/sdc1: LABEL="PRUEBAS" UUID="F839-2B41" TYPE="vfat"
^^^^^^^^^^^^^^
That's my small USB flash drive (128 MiB) with just one partition on it
that's labeled "PRUEBAS" and then I can mount it by issuing:
sm01@stt008:~$ umount /media/PRUEBAS
stt008:~# mount -L PRUEBAS /media
stt008:~# mount|grep -i sdc
/dev/sdc1 on /media type vfat (rw)
How to give a label to a partition? I always make that step when
formatting the drive but it can be done afterwards with "tune2fs" or