Re: USB3.0 problem: xhci_hcd not found

[Krzysztof Bieniasz <krzysztof.t.bieniasz@gmail.com>]

> Have you installed 'firmware-linux'?  There is 3 packages. --
> Jimmy Johnson

Thanks for you're advice, I did that now and the port seams to work fine. 
That is I can connect a flash drive and it gets mounted. But the annoying 
message is still there during boot. When I run "dmesg" I get a couple of 
tens of the following lines:

[   76.966101] usb 1-1.5: new full speed USB device using ehci_hcd and 
address X
[   76.982454] hub 1-1:1.0: unable to enumerate USB device on port 5

These messages continue through all the session, only the numbers in the 
[] braces and the "X" change. You can imagine I'd like them to go away. 
Any ideas?

Regards,
KB