On 01/14/2011 07:43 PM, Bonno Bloksma wrote:
AFAIK, allow-hotplug makes the interface come up only when a cable is plugged in. auto makes the interface come up at boot time regardless of the cable state.Hi,# The primary network interface allow-hotplug eth0 iface eth0 inet dhcp allow hotplug eth1 iface eth1 inet dhcpreplace 'allow hotplug' with 'auto' auto eth0 auto eth1I have been wondering about this and have not seen any definitive documentation, or if there is, I have not understood it. Does "auto" imply "allow-hotplug"? If not, should I have both auto eth0 eth1 and allow-hotplug eth0 eth1 lines in my interfaces file? Bonno Bloksma
Mihira.