networking
so, i've got some debian boxes in a virtualbox environment. most work
fine, but one is annoying me.
after i boot it, the first interface comes up fine, but not the
second. if i run '/etc/init.d/networking restart' they both go down.
here is my ifconfig and interfaces file (which both look pretty normal
to me):
swilson-mbp-vdebian:~# ifconfig -a
eth0 Link encap:Ethernet HWaddr 08:00:27:8d:ce:55
inet addr:10.0.2.15 Bcast:10.0.2.255 Mask:255.255.255.0
inet6 addr: fe80::a00:27ff:fe8d:ce55/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:11 errors:0 dropped:0 overruns:0 frame:0
TX packets:24 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:2881 (2.8 KiB) TX bytes:3131 (3.0 KiB)
eth1 Link encap:Ethernet HWaddr 08:00:27:f6:03:08
inet addr:192.168.56.102 Bcast:192.168.56.255 Mask:255.255.255.0
inet6 addr: fe80::a00:27ff:fef6:308/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:902 errors:0 dropped:0 overruns:0 frame:0
TX packets:133 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:65559 (64.0 KiB) TX bytes:20082 (19.6 KiB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
swilson-mbp-vdebian:~# cat /etc/network/interfaces
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface
allow-hotplug eth0
iface eth0 inet dhcp
allow hotplug eth1
iface eth1 inet dhcp
Reply to: