[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Realtek Device ffff (rev 10) is not recognized with 8139too

Hello,

I had two network cards in my micro. The eth0 card was stopped (ruined) and I,
for one time, worked without it (only with eth1). All is working perfectly.

Now a days I moved my DIAL UP to ADSL and I will need to share my
net. I am at home.

I bought a new PCI card and plug it. But it is not recognized.

In the logs, see below, it appears that it was renamed from eth0 to eth1.

You know if the driver 8139too is really the one for this hardware? What
I could do to configure it?

Here are the outputs of some commands.

:~$ uname -a
Linux maq 2.6.26-2-486 #1 Thu Mar 26 00:13:41 UTC 2009 i686 GNU/Linux

:~$ sudo modprobe 8139too

:~$ lsmod
Module                  Size  Used by
8139too                20096  0 
mii                     4864  1 8139too

:~$ sudo ifconfig eth0 up
eth0: ERROR while getting interface flags: Dispositivo inexistente

dmesg log:

[    2.724640] forcedeth 0000:00:04.0: ifname eth0, PHY OUI 0x732 @ 1, addr
00:0c:6e:b2:40:58
[    5.098215] udev: renamed network interface eth0 to eth1
[   25.960017] eth1: no IPv6 routers present

kernel log:

May 31 09:08:02 maq kernel: [    2.720643] forcedeth 0000:00:04.0: ifname eth0,
PHY OUI 0x732 @ 1, addr 00:0c:6e:b2:40:58
May 31 09:08:02 marcella kernel: [    2.720730] forcedeth 0000:00:04.0: timirq
lnktim desc-v1
May 31 09:08:02 maq kernel: [    5.094380] udev: renamed network interface eth0
to eth1
May 31 09:08:02 maq kernel: [   26.040022] eth1: no IPv6 routers present

:~$ lspci -vv
01:09.0 Ethernet controller: Realtek Semiconductor Co., Ltd. Device ffff (rev 10)
	Subsystem: Realtek Semiconductor Co., Ltd. Device 8139
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping-
SERR- FastB2B- DisINTx-
	Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR- INTx-
	Latency: 32 (8000ns min, 16000ns max)
	Interrupt: pin A routed to IRQ 5
	Region 0: I/O ports at c400 [size=256]
	Region 1: Memory at df000000 (32-bit, non-prefetchable) [size=256]
	[virtual] Expansion ROM at 30000000 [disabled] [size=64K]
	Capabilities: <access denied>

:~$ lspci -vv | grep -i driver 
	Kernel driver in use: agpgart-nvidia
	Kernel driver in use: nForce2_smbus
	Kernel driver in use: ohci_hcd
	Kernel driver in use: ohci_hcd
	Kernel driver in use: ehci_hcd
	Kernel driver in use: forcedeth
	Kernel driver in use: Intel ICH
	Kernel driver in use: AMD_IDE
	Kernel driver in use: serial
	Kernel driver in use: nvidia

:~$ sudo ifconfig -a
eth1      Link encap:Ethernet  Endereço de HW 00:0c:6e:b2:40:58  
          inet end.: 192.168.1.2  Bcast:192.168.1.255  Masc:255.255.255.0
          endereço inet6: fe80::20c:6eff:feb2:4058/64 Escopo:Link
          UP BROADCASTRUNNING MULTICAST  MTU:1500  Métrica:1
          RX packets:30453 errors:0 dropped:0 overruns:0 frame:0
          TX packets:27266 errors:0 dropped:0 overruns:0 carrier:0
          colisões:0 txqueuelen:1000 
          RX bytes:31551294 (30.0 MiB)  TX bytes:4070306 (3.8 MiB)
          IRQ:21 Endereço de E/S:0xa000 

lo        Link encap:Loopback Local  
          inet end.: 127.0.0.1  Masc:255.0.0.0
          endereço inet6: ::1/128 Escopo:Máquina
          UP LOOPBACKRUNNING  MTU:16436  Métrica:1
          RX packets:3905 errors:0 dropped:0 overruns:0 frame:0
          TX packets:3905 errors:0 dropped:0 overruns:0 carrier:0
          colisões:0 txqueuelen:0 
          RX bytes:158626 (154.9 KiB)  TX bytes:158626 (154.9 KiB)

ppp0      Link encap:Protocolo Ponto-a-Ponto  
          inet end.: 189.xxx.xxx.xxx  P-a-P:200.xxx.xxx.xxx  Masc:255.255.255.255
          UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1492  Métrica:1
          RX packets:10773 errors:0 dropped:0 overruns:0 frame:0
          TX packets:10632 errors:0 dropped:0 overruns:0 carrier:0
          colisões:0 txqueuelen:3 
          RX bytes:9575731 (9.1 MiB)  TX bytes:1873021 (1.7 MiB)

wlan0     Link encap:Ethernet  Endereço de HW 00:13:46:6d:cf:b1  
          inet end.: 10.0.0.1  Bcast:10.255.255.255  Masc:255.0.0.0
          endereço inet6: fe80::213:46ff:fe6d:cfb1/64 Escopo:Link
          UP BROADCASTMULTICAST  MTU:1500  Métrica:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:80 errors:0 dropped:0 overruns:0 carrier:0
          colisões:0 txqueuelen:1000 
          RX bytes:0 (0.0 B)  TX bytes:14850 (14.5 KiB)

wmaster0  Link encap:Não Especificado  Endereço de HW
00-13-46-6D-CF-B1-65-74-00-00-00-00-00-00-00-00  
          UP BROADCASTRUNNING MULTICAST  MTU:1500  Métrica:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          colisões:0 txqueuelen:1000 
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)

:~$ cat /etc/network/interfaces 
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface
auto lo
iface lo inet loopback

# The primary network interface
allow-hotplug eth1
iface ppp0 inet ppp
provider ppp0

auto ppp0

#iface eth0 inet static
#address 192.168.0.1
#netmask 255.255.255.0
#gateway 192.168.0.1

#auto eth0

iface eth1 inet static
address 192.168.1.2
netmask 255.255.255.0
gateway 192.168.1.1

#auto eth1

auto dsl-provider
iface dsl-provider inet ppp
pre-up /sbin/ifconfig eth1 up # line maintained by pppoeconf
provider dsl-provider

Thank you so much!

Marcelo
Reply to: