Re: problems with module-assistant and gspca
On Fri, Nov 14, 2008 at 20:48:53 -0200, Marcelo Chiapparini wrote:
> Hello,
>
> I am running etch and I have a pleomax pwc-2100 webcam by Pixart Imaging
> Inc. The pwc-2100 doesn't run out the box. After googling a bit, I found
> that it needs the gspca module. I installed the gspca-source and
> followed the instructions in /usr/share/doc/gspca-source/readme.debian:
>
> $ m-a prepare
> $ m-a a-i gspca
>
> the process ends with errors. Looking at the log file in the
> module-assistant log file viewer, I found the following lines which
> report errors:
>
> scripts/Makefile.build:46: *** CFLAGS was changed in
> "/usr/src/modules/gsp (<-----line is out of margins here)
> make[3]: *** [_module_/usr/src/modules/gspca] Error 2
> make[3]: Leaving directory '/usr/src/linux-headers-2.6.26-bpo.1-686'
> make[2]: *** [default] Error 2
> make[2]: Leaving directory '/usr/src/modules/gspca'
> make[1]: *** [binary-modules] Error 2
> make[1]: Leaving directory '/usr/src/modules/gspca'
> make: *** [kdist-build] Error 2
>
>
> I never used module-assistant before. Any help will be very much
> appreciated!
Which version of gspca-source do you use? It seems that you are running
a backported 2.6.26 kernel, so maybe you need to use the newer
gspca-source package from Lenny. (Unfortunately, a backported package of
the newer gspca-source version does not seem to be available.)
--
Regards, | http://users.icfo.es/Florian.Kulzer
Florian |
Reply to: