[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: Printer setup problem in Etch

On Tue, Oct 02, 2007 at 11:01:00PM -0400, Bob C wrote:
> I checked my bios setup and under Parellel Port Mode found four choices.
> Normal, Bi-directional, EPP and ECP. I experienced the printer problem
> with the bios set to ECP. 
> When I choose Normal, the printer now works.

Normal is uni-directional.  ECP and EPP are both bidirectional.  I don't
know if your print spooler would prefer bidirectional, in which case try


Reply to: