Re: cups and samba stop working after upgrade to etch
On Fri, Apr 20, 2007 at 11:25:26 -0400, Bill Shofner wrote:
> After upgrading my sarge box to etch, I cannot print and samba no longer
> works. When I re-boot I get the following message from root:
>
> The Samba 'panic action' script, /usr/share/samba/panic-action,
> was called for PID 2540 (/usr/sbin/smbd).
>
> This means there was a problem with the program, such as a segfault.
> Below is a backtrace for this process generated with gdb, which shows
> the state of the program at the time the error occurred. The Samba log
> files may contain additional information about the problem.
[...]
> I cannot print from the printer attached to this system either and when I
> try to go to http://localhost:631 I get:
>
> An error occurred while loading http://localhost:631:
> Could not connect to host localhost (port 631).
[...]
> At this point I do not know if the underlying problem is in cups or samba
> or something else. Any pointers or suggestions will be greatfully received.
Just to get this out of the way first: Are you sure that your upgrade is
complete? Did you use the procedure outlined in the release notes?
--
Regards, | http://users.icfo.es/Florian.Kulzer
Florian |
Reply to: