Re: Check for USB connections

[Matthew K Poer <matthewpoer@gmail.com>]

On Sun, 2007-03-18 at 12:55 -0300, Alejandro wrote:
> Dear all, I have Debian Etch connected to a HP printer through an USB 
> port  but it is not recognized. A pair of months ago the printer worked 
> perfectly, and I could see it using "lsusb" command. After that I 
> disconnect the printer and now I connect it again to my Debian, but 
> "lsusb" command doesn't show anything about USB connections.
> 
> The output fromn "lshw" command is this:
> 
> *-usb:0
>             description: USB Controller
>             product: VT82xxxxx UHCI USB 1.1 Controller
>             vendor: VIA Technologies, Inc.
>             physical id: 7.2
>             bus info: pci@00:07.2
>             version: 16
>             width: 32 bits
>             clock: 33MHz
>             capabilities: uhci bus_master cap_list
>             configuration: driver=uhci_hcd latency=32
>             resources: ioport:c400-c41f irq:3
>        *-usb:1
>             description: USB Controller
>             product: VT82xxxxx UHCI USB 1.1 Controller
>             vendor: VIA Technologies, Inc.
>             physical id: 7.3
>             bus info: pci@00:07.3
>             version: 16
>             width: 32 bits
>             clock: 33MHz
>             capabilities: uhci bus_master cap_list
>             configuration: driver=uhci_hcd latency=32
>             resources: ioport:c800-c81f irq:3
> 
> How can I check where is my problem ???
> 
> Really thanks
> 
> alejandro.-
> 
> 
Try a differant USB port? Perhaps the one you are using is broken.
-- 
Matthew K Poer