[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

SunBlade150 (Sparc64) random system freeze



Hi,

I am running Debian Testing on SunBlade150 with kernel 2.6.16. It used
to run kernel 2.6.8 before the upgrade. Irrespective of the kernel
version, I am facing system freezing randomly with no traces in any of
the logs. Many times system keeps running for 40 days and many times
it will just hang after booting up.

I could reproduce the similar issues on two more excatly same
machines. They were used to hang even during net-install itself when
APT was installing packages. It has been more than 1 year I am facing
the problem without any solutions.

Earlier I was using KDE, but since when I have switched to IceWM, the
frequency of freeze is reduced but it is still there.

regards,
Nishant

Here are my lspci and dmesg outputs:

=========================
sunny:~# lspci
00:00.0 Host bridge: Sun Microsystems Computer Corp. Ultra IIe
00:03.0 Non-VGA unclassified device: ALi Corporation M7101 Power
Management Controller [PMU]
00:05.0 PCI bridge: Intel Corporation 21152 PCI-to-PCI Bridge
00:07.0 ISA bridge: ALi Corporation M1533/M1535 PCI to ISA Bridge
[Aladdin IV/V/V+]
00:08.0 Multimedia audio controller: ALi Corporation M5451 PCI AC-Link
Controller Audio Device (rev 01)
00:0c.0 Bridge: Sun Microsystems Computer Corp. RIO EBUS (rev 01)
00:0c.1 Ethernet controller: Sun Microsystems Computer Corp. RIO GEM (rev 01)
00:0c.2 FireWire (IEEE 1394): Sun Microsystems Computer Corp. RIO 1394 (rev 01)
00:0c.3 USB Controller: Sun Microsystems Computer Corp. RIO USB (rev 01)
00:0d.0 IDE interface: ALi Corporation M5229 IDE (rev c3)
00:13.0 VGA compatible controller: ATI Technologies Inc Rage XL (rev 27)
=========================
sunny:~# dmesg
PROMLIB: Sun IEEE Boot Prom 4.10.6 2003/06/06 12:30
Linux version 2.6.16-2-sparc64 (Debian 2.6.16-18) (fs@debian.org) (gcc
version 4.0.4 20060730 (prerelease) (Debian 4.0.3-6)) #1 Wed Aug 30
11:31:31 CEST 2006
ARCH: SUN4U
Ethernet address: 00:03:ba:cd:ba:c0
On node 0 totalpages: 64314
 DMA zone: 64314 pages, LIFO batch:15
 DMA32 zone: 0 pages, LIFO batch:0
 Normal zone: 0 pages, LIFO batch:0
 HighMem zone: 0 pages, LIFO batch:0
CPU[0]: Caches D[sz(16384):line_sz(32)] I[sz(16384):line_sz(32)]
E[sz(524288):line_sz(64)]
Built 1 zonelists
Kernel command line: root=/dev/hda2 ro noapic nolapic
PID hash table entries: 2048 (order: 11, 65536 bytes)
Console: colour dummy device 80x25
Dentry cache hash table entries: 65536 (order: 6, 524288 bytes)
Inode-cache hash table entries: 32768 (order: 5, 262144 bytes)
Memory: 504104k available (2040k kernel code, 696k data, 136k init)
[fffff80000000000,000000004ff20000]
Calibrating delay loop... 1097.72 BogoMIPS (lpj=2195456)
Security Framework v1.0.0 initialized
SELinux:  Disabled at boot.
Capability LSM initialized
Mount-cache hash table entries: 512
checking if image is initramfs... it is
Freeing initrd memory: 4461k freed
NET: Registered protocol family 16
PCI: Probing for controllers.
PCI: Found SABRE, main regs at 000001fe00000000
SABRE: Shared PCI config space at 000001fe01000000
SABRE: DVMA at c0000000 [20000000]
PCI quirk: region 0800-083f claimed by ali7101 ACPI
PCI quirk: region 0600-061f claimed by ali7101 SMB
PCI-IRQ: Routing bus[ 0] slot[ 8] map[0] to INO[23]
PCI-IRQ: Routing bus[ 0] slot[ c] map[0] to INO[06]
PCI-IRQ: Routing bus[ 0] slot[ c] map[0] to INO[1c]
PCI-IRQ: Routing bus[ 0] slot[ c] map[0] to INO[24]
PCI-IRQ: Routing bus[ 0] slot[ d] map[0] to INO[0c]
PCI-IRQ: Routing bus[ 0] slot[13] map[0] to INO[0f]
PCI0(PBMA): Bus running at 33MHz
isa0: [dma -> (floppy) (parallel)] [power] [serial] [serial]
ebus0: [flashprom] [eeprom] [idprom]
power: Control reg at 000001fe02000800 ... powerd running.
usbcore: registered new driver usbfs
usbcore: registered new driver hub
audit: initializing netlink socket (disabled)
audit(1164362699.196:1): initialized
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 8192 bytes)
Initializing Cryptographic API
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
Activating ISA DMA hang workarounds.
atyfb: 3D RAGE XL (Mach64 GR, PCI-33) [0x4752 rev 0x27]
atyfb: 8M SDRAM (1:1), 29.498928 MHz XTAL, 235 MHz PLL, 83 Mhz MCLK, 63 MHz XCLK
Console: switching to colour frame buffer device 160x64
atyfb: fb0: ATY Mach64 frame buffer device on PCI
rtc_init: no PC rtc found
[drm] Initialized drm 1.0.1 20051102
ttyS0 at MMIO 0x1fe020003f8 (irq = 7254624) is a 16550A
ttyS1 at MMIO 0x1fe020002e8 (irq = 7254624) is a 16550A
isa bounce pool size: 16 pages
RAMDISK driver initialized: 16 RAM disks of 16384K size 1024 blocksize
loop: loaded (max 8 devices)
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
rtc_sun_init: Registered Mostek RTC driver.
usbmon: debugfs is not available
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.6:USB HID core driver
mice: PS/2 mouse device common for all mice
NET: Registered protocol family 2
IP route cache hash table entries: 4096 (order: 2, 32768 bytes)
TCP established hash table entries: 16384 (order: 4, 131072 bytes)
TCP bind hash table entries: 16384 (order: 4, 131072 bytes)
TCP: Hash tables configured (established 16384 bind 16384)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
ALI15X3: IDE controller at PCI slot 0000:00:0d.0
ALI15X3: chipset revision 195
ALI15X3: 100% native mode on irq 4,7cc
   ide0: BM-DMA at 0x1fe02000a20-0x1fe02000a27, BIOS settings: hda:pio, hdb:pio
   ide1: BM-DMA at 0x1fe02000a28-0x1fe02000a2f, BIOS settings: hdc:pio, hdd:pio
Probing IDE interface ide0...
hda: ST380011A, ATA DISK drive
ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
ieee1394: Initialized config rom entry `ip1394'
hdb: MATSHITADVD-ROM SR-8589, ATAPI CD/DVD-ROM drive
ide0 at 0x1fe02000a00-0x1fe02000a07,0x1fe02000a1a on irq 4,7cc
Probing IDE interface ide1...
ohci_hcd 0000:00:0c.3: OHCI Host Controller
ohci_hcd 0000:00:0c.3: new USB bus registered, assigned bus number 1
ohci_hcd 0000:00:0c.3: irq 9,7e4, io mem 0x1ff02000000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 4 ports detected
hda: max request size: 128KiB
ohci1394: fw-host0: OHCI-1394 1.0 (PCI): IRQ=[10,7dc]
MMIO=[1ff00420000-1ff004207ff]  Max Packet=[2048]  IR/IT
contexts=[4/4]
sungem.c:v0.98 8/24/03 David S. Miller (davem@redhat.com)
PHY ID: 4061e4, addr: 1
eth0: Sun GEM (PCI) 10/100/1000BaseT Ethernet 00:03:ba:cd:ba:c0
eth0: Found BCM5221 PHY
hda: 156301488 sectors (80026 MB) w/2048KiB Cache, CHS=16383/255/63, UDMA(66)
usb 1-2: new low speed USB device using ohci_hcd and address 2
hda: cache flushes supported
hda: hda1 hda2 hda3 hda4 hda5
hdb: ATAPI 48X DVD-ROM drive, 256kB Cache
Uniform CD-ROM driver Revision: 3.20
usb 1-2: configuration #1 chosen from 1 choice
input: HID 0430:0100 as /class/input/input0
input: USB HID v1.10 Mouse [HID 0430:0100] on usb-0000:00:0c.3-2
usb 1-4: new low speed USB device using ohci_hcd and address 3
usb 1-4: configuration #1 chosen from 1 choice
input: HID 0430:0005 as /class/input/input1
input: USB HID v1.00 Keyboard [HID 0430:0005] on usb-0000:00:0c.3-4
ieee1394: Host added: ID:BUS[0-00:1023]  GUID[0003bafffecdbac0]
EXT3-fs: INFO: recovery required on readonly filesystem.
EXT3-fs: write access will be enabled during recovery.
eth0: Link is up at 100 Mbps, full-duplex.
kjournald starting.  Commit interval 5 seconds
EXT3-fs: hda2: orphan cleanup on readonly fs
ext3_orphan_cleanup: deleting unreferenced inode 458010
EXT3-fs: hda2: 1 orphan inode deleted
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
eth1394: eth1: IEEE-1394 IPv4 over 1394 Ethernet (fw-host0)
Adding 747000k swap on /dev/hda4.  Priority:-1 extents:1 across:747000k
EXT3 FS on hda2, internal journal
Probing IDE interface ide1...
device-mapper: 4.5.0-ioctl (2005-10-04) initialised: dm-devel@redhat.com
kjournald starting.  Commit interval 5 seconds
EXT3 FS on hda1, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting.  Commit interval 5 seconds
EXT3 FS on hda5, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
NET: Registered protocol family 15
eth0: Link is up at 100 Mbps, full-duplex.
eth0: Pause is disabled
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
IPv6 over IPv4 tunneling driver
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
NFSD: Using /var/lib/nfs/v4recovery as the NFSv4 state recovery directory
NFSD: starting 90-second grace period
eth0: no IPv6 routers present
ioctl32(Xorg:4774): Unknown cmd fd(6) cmd(40584606){00} arg(ef8b7a7c)
on /dev/fb0
ioctl32(Xorg:4774): Unknown cmd fd(6) cmd(40184600){00} arg(ef8b7a84)
on /dev/fb0
tun: Universal TUN/TAP device driver, 1.6
tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
===============================



Reply to: