Re: Need help installing RAID 0+1

[Morgan Reed <morgan@whickedwheels.com>]

Peter,

thanks, I actually did use that guide to do the set-up, and it was  
very helpful.  the problem I have is how do I move from having either  
a RAID0 or RAID1 to having BOTH.

I have the four disks broken up into two RAID0 arrays of two disks  
each.  what I want to do now is have the two RAID0 disks be  
'mirrored'  to each other - i.e. RAID1

when I try to use the "Create MD"  It am told that I don't have any  
RAID partitions;  but I can't set the RAID) partitions to physical  
RAID partition either.

so that's where I am stalled out.  I have the two RAID0 but can't  
figure out how to create a RAID1 out of them.

-M


On Feb 20, 2006, at 1:52 PM, Peter Colton wrote:

> On Monday 20 February 2006 16:47, Morgan Reed wrote:
> > Fresh install of Debian 3.1 on a box with 4 SCSI 18.2 GB HD.  SCSI
> > card is a non-RAID adaptec card.
> >
> > I am trying to set up the 4 drives as 2 RAID0 of 36 Gig each mirrored
> > (RAID1)
>
> > Morgan
>
> 	Hello Morgan,
>
> 	Have a look at the link below its should be of help setting up a  
> software
> raid1. If you are using lvm as well at the beging of the expert  
> install, pick
> the mdcfg module and the lvmcfg module.
>
> 	" Installing Debian Sarge with software RAID "
> 	http://nepotismia.com/debian/raidinstall/
>
>
> 		Regards
>
>                         peter colton
>
>
> --
> To UNSUBSCRIBE, email to debian-user-REQUEST@lists.debian.org
> with a subject of "unsubscribe". Trouble? Contact  
> listmaster@lists.debian.org