[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Help: Sarge network configuration

hello, I just installed the debian 3.1r0 base system using CDImage file from debian,org and want to install others from internet. But now I cann't access internet.

during the first stage of installation, DHCP was checked, it works and the installation didn't ask me to further config the network. Then in the second stage of installation I can not access the listed http or ftp servers for the additional packages.

The reason is that DHCP is only valid in our department network and for www I can only access it through the fixed IP address given to this machine.

So I edit /etc/network/interfaces as the following and then reboot the system(I don't know how to enact this file). With command 'base-config', I still cann't be connected to the ftp servers.
auto lo
iface lo inet loopback

auto eht0
iface eth0 inet static

PS:1. my network card is: D-Link DFE-530TX-PCI-Fast Ethernetadapter(rev.B)
2. this is the boot information which concerns eth0:
eth0: VIA VT6102 Rhine-II at oxd400 00:50:BA:EB:1C:7D, IRQ 11
eth0: MII PHY found at address 8, status ox7829 advertising 01e1 Link 45e1
eth0: Setting full-duplex based on MII #8 link partner capability of 45e1

Reply to: