Re: hotplug, udev and usbkey question

[Bob Alexander <bob@ngi.it>]

John L Fjellstad wrote:
> Bob Alexander <bob@ngi.it> writes:
>
>
> > But I still have a problem. The /dev/usbkey device is still not created.
> >
> > Reading your very good explanation I also believe it should already
> > have since I also had the following (0644 root.root):
> >
> > bob@t40:/etc/udev/rules.d$ cat 10-local.rules
> > BUS="usb", KERNEL="sd?1", SYSFS{serial}="0206430D0A001CBC", NAME="usbkey"
> >
> > syslog only shows the creation of the sda* devices from
> > /etc/udev/rules.d/z_hal-plugdev.rules
> >
> > Any other things to look at ?
>
>
> Could post your syslog entries for udev when inserting the usb key.  One
> thing I would look at is removing "KERNEL=sd?1".  At my place, the usb
> key is uba1. I wonder if the rule is too specific.
>   

There you go John,
here is what goes into syslog when I insert the usbkey.

Have a nice weekend,
Bob

Mar 19 09:33:17 localhost kernel: usb 4-3: new high speed USB device 
using ehci_hcd and address 3
Mar 19 09:33:18 localhost kernel: SCSI subsystem initialized
Mar 19 09:33:18 localhost kernel: Initializing USB Mass Storage driver...
Mar 19 09:33:18 localhost kernel: scsi0 : SCSI emulation for USB Mass 
Storage devices
Mar 19 09:33:18 localhost kernel: usbcore: registered new driver usb-storage
Mar 19 09:33:18 localhost kernel: USB Mass Storage support registered.
Mar 19 09:33:18 localhost usb.agent[6457]:      usb-storage: loaded 
successfullyMar 19 09:33:18 localhost kernel: usb-storage: device found at 3
Mar 19 09:33:18 localhost kernel: usb-storage: waiting for device to 
settle before scanning
Mar 19 09:33:23 localhost kernel:   Vendor:           Model: USB Flash 
Memory  Rev: 1.00
Mar 19 09:33:23 localhost kernel:   Type:   Direct-Access 
       ANSI SCSI revision: 00
Mar 19 09:33:23 localhost kernel: usb-storage: device scan complete
Mar 19 09:33:23 localhost scsi.agent[6575]: disk at 
/devices/pci0000:00/0000:00:1d.7/usb4/4-3/4-3:1.0/host0/target0:0:0/0:0:0:0
Mar 19 09:33:24 localhost kernel: SCSI device sda: 246272 512-byte hdwr 
sectors
(126 MB)
Mar 19 09:33:24 localhost kernel: sda: assuming Write Enabled
Mar 19 09:33:24 localhost kernel: sda: assuming drive cache: write through
Mar 19 09:33:24 localhost kernel: SCSI device sda: 246272 512-byte hdwr 
sectors
(126 MB)
Mar 19 09:33:24 localhost kernel: sda: assuming Write Enabled
Mar 19 09:33:24 localhost kernel: sda: assuming drive cache: write through
Mar 19 09:33:24 localhost kernel:  sda: sda1
Mar 19 09:33:24 localhost kernel: Attached scsi removable disk sda at 
scsi0, channel 0, id 0, lun 0
Mar 19 09:33:24 localhost udev[6606]: configured rule in 
'/etc/udev/rules.d/z_hal-plugdev.rules[2]' applied, 'sda' becomes '%k'
Mar 19 09:33:24 localhost udev[6606]: creating device node '/dev/sda'
Mar 19 09:33:24 localhost udev[6624]: configured rule in 
'/etc/udev/rules.d/z_hal-plugdev.rules[2]' applied, 'sda1' becomes '%k'
Mar 19 09:33:24 localhost udev[6624]: creating device node '/dev/sda1'