New install with HDD from MAXTOR SATA/150 controller
Hello,
I have an older computer (PII) but with enough RAM and a HDD from 120 GB
connected via an addon MAXTOR SATA/150 card.
When i boot, the computer sees the sata pci card AND the hdd.
Then i install debian and he also sees the promise chipset from the card
but the modules or whatever or not available at that time of the
installation.
When i have to partition my hdd, i get the error that no partition media
can be found so debian is not seeing the HDD via the controller.
How can i change this ? Or is it not possible ?
Cheers,
Philippe.
Disclaimer :
This e-mail is intended for the exclusive use by the person(s) mentioned as recipient(s).
If you are not the intended recipient, please notify us immediately.
This e-mail does not constitute any commitment for Sea-Ro Terminal N.V. or its subsidiaries except when expressly otherwise
agreed in a written agreement between the intended recipient and the originating subsidiaries of Sea-Ro Terminal N.V.
Sea-Ro Terminal and each of its subsidiaries each reserve the right to monitor all e-mail communications through its networks.
This mail has been checked for viruses by Symantec and Trend Micro.
Reply to: