Re: Adaptec 2100S: System freeze when trying to backup with tar
Citat Marc Mueller <marc-mueller@email.de>:
> Try using the "dpt_i2o" driver (Adaptec I2O RAID support) instead of the
> i2o_* modules.
>
> Marc
>
that's the one I'm using. sorry for the poor information, had no conection to my
server and didn't remember everything.
here is all information about my controler:
vwclub:/etc# cat /proc/scsi/dpt_i2o/0
Adaptec I2O RAID Driver Version: 2.4 Build 5
Vendor: Adaptec Model: 2100S FW:370F
SCSI Host=scsi0 Control Node=/dev/dpti0 irq=11
post fifo size = 255
reply fifo size = 255
sg table size = 56
Devices:
ADAPTEC RAID-1 Rev: 370F
TID=517, (Channel=0, Target=4, Lun=0) (online)
vwclub:/etc# cat /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 00 Id: 04 Lun: 00
Vendor: ADAPTEC Model: RAID-1 Rev: 370F
Type: Direct-Access ANSI SCSI revision: 02
RAIDUTIL Version: 3.31 Date: 8/12/2002 LINUX CLI Configuration Utility
Adaptec ENGINE Version: 3.31 Date: 8/12/2002 Adaptec LINUX SCSI Engine
# b0 b1 b2 Controller Cache FW NVRAM Serial Status
---------------------------------------------------------------------------
d0 -- ADAP2100S 16MB 370F CHNL 1.1 BF0B12620AHOptimal
Physical View
Address Type Manufacturer/Model Capacity Status
---------------------------------------------------------------------------
d0b0t4d0 Disk Drive (DASD) IBM DDYS-T36950N 35003MB Optimal
d0b0t8d0 Disk Drive (DASD) IBM DDYS-T36950N 35003MB Optimal
Logical View
Address Type Manufacturer/Model Capacity Status
---------------------------------------------------------------------------
d0b0t4d0 RAID 1 (Mirrored) ADAPTEC RAID-1 35003MB Optimal
d0b0t4d0 Disk Drive (DASD) IBM DDYS-T36950N 35003MB Optimal
d0b0t8d0 Disk Drive (DASD) IBM DDYS-T36950N 35003MB Optimal
Address Max Speed Actual Rate / Width
---------------------------------------------------------------------------
d0b0t4d0 Ultra3 160 MB/sec wide
d0b0t8d0 Ultra3 160 MB/sec wide
Address Manufacturer/Model Write Cache Mode
---------------------------------------------------------------------------
d0b0t4d0 ADAPTEC RAID-1 Write Back
d0b0t4d0 IBM DDYS-T36950N Write Back
d0b0t8d0 IBM DDYS-T36950N Write Back
# Controller Cache FW NVRAM BIOS SMOR Serial
---------------------------------------------------------------------------
d0 ADAP2100S 16MB 370F CHNL 1.1 1.62 1.12/79I BF0B12620AH
# Controller Status Voltage Current Full Cap Rem Cap Rem Time
---------------------------------------------------------------------------
d0 ADAP2100S No battery
Address Manufacturer/Model FW Serial 123456789012
---------------------------------------------------------------------------
d0b0t4d0 IBM DDYS-T36950N S93E 5FLB9465 -XXXX---XOX-
d0b0t8d0 IBM DDYS-T36950N S93E VFLAP060 -XXXX---XOX-
Capabilities Map: Column 1 = Soft Reset
Column 2 = Cmd Queuing
Column 3 = Linked Cmds
Column 4 = Synchronous
Column 5 = Wide 16
Column 6 = Wide 32
Column 7 = Relative Addr
Column 8 = SCSI II
Column 9 = S.M.A.R.T.
Column 0 = SCAM
Column 1 = SCSI-3
Column 2 = SAF-TE
X = Capability Exists, - = Capability does not exist, O = Not Supported
Reply to: