Re: Looking for tips on ppp problem: LCP ConfReq
On Thu, Jun 26, 2003 at 07:33:46AM +0200, Thomas Krennwallner wrote:
> Hi!
>
> On Wed Jun 25, 2003 at 11:46:00PM +0200, Hugo van der Merwe wrote:
> > gateway/firewall/webserver. I had to move it to a modem for a while,
> > however, it refuses to connect. The laptop, however, with pretty much
> > an identical setup, connects without a hitch. So at the moment I've
> > got the laptop set up as gateway so that I can send this.
>
> What are the modem manufacturers? Do you connect with a US Robotics on
> the gateway and with the internal modem of the laptop?
Same modem, both cases, a Dynalink external 56K modem. I ahve an old
US Robotics 28800 as well though, I could give that a try...
> I had a similar problem yesterday. I have a US Robotics Sportster
> Message Plus. All went well except those pesky hangups without any
> special reason.
>
> So I found a french (sic!) page and I only could read some thoughts on
> USR AT commands. So I added AT&F1 before the ATDT stuff and voilà it
> worked without a hassle.
My init string is currently "ATQ0 V1 E1 S0=0 &C1 &D2 S11=55 +FCLASS=0"
- IIRC that was what wvdialconf recommends (though I don't use
wvdial). I will also try adding &F1, thanks...
> I don't know if you use a USR modem but I think your problem lies within
> some special AT commands to setup your modem properly. Maybe there are
> some helping codes in the Modem-HOWTO.
OK, my plan of action:
1) Add &F1 for Dynalink
2) Try US Robotics modem instead of Dynamlink
3) Try &F1 addition for US Robotics
4) Check modem howto
Thanks,
Hugo van der Merwe
--
The earth's surface is accelerating outward at 9.8 meters per sec^2
1024D/60715698: 5F2E 8EC2 E0A4 5D25 0569 F281 4A6C D76D 6071 5698
Reply to: