Kodak DC220 USB Camera
I'm trying to install this camera using the hotplug utilities and the gphoto2
webpage.
I have figured out that gtkam and gimp use the same set up libs for doing
this so I've been using gtkam as the interface to get this rolling as it has
the DEBUG option.
They (gphoto) have a number of errors in their pages, so I'm not sure how to
configure this device anymore.
I have removed the driver, dc2xx from my /etc/modules.conf using 'modconf'.
And when I plug it in.....
Jun 10 06:25:40 bilbo kernel: hub.c: new USB device 00:07.2-2, assigned address 2
Jun 10 06:25:40 bilbo kernel: usb.c: USB device 2 (vend/prod 0x40a/0x100) is
not claimed by any active driver.
Jun 10 06:25:43 bilbo kernel: usb.c: registered new driver dc2xx
Jun 10 06:25:43 bilbo kernel: dc2xx.c: USB Camera #0 connected, major/minor
180/80
Jun 10 06:25:43 bilbo kernel: dc2xx.c: v1.0.0:USB Camera Driver for Kodak
DC-2xx series cameras
From this, it appears that the device is valid and registered on the USB bus.
gtkam is able to detect this camera....
Looking for USB device (vendor 0x40a, product 0x100)... found.
Detected defaults: config 1, interface 0, altsetting 0, inep 81, outep 02,
intep ffffffff
Found 'Kodak DC220' (0x40a,0x100)
Freeing port...
Closing port...
Counting entries (3 available)...
2 regular entries available.
Getting info of entry 0 (3 available)...
Getting info of entry 1 (3 available)...
Counting entries (3 available)...
2 regular entries available.
Getting info of entry 0 (3 available)...
Getting info of entry 1 (3 available)...
But when I attempt to Apply these settings it fails to initialize the device
(use gtkam):
Internally appending folder /...
Creating new device...
Setting abilities ('Kodak DC220')...
Looking for path 'usb:' (3 entries available)...
Getting info of entry 1 (3 available)...
Setting port info for port 'Universal Serial Bus' at 'usb:'...
Setting timeout to 5000 millisecond(s)...
Setting settings...
Initializing camera...
Looking for USB device (vendor 0x40a, product 0x100)... found.
Detected defaults: config 1, interface 0, altsetting 0, inep 81, outep 02,
intep ffffffff
Loading '/usr/lib/gphoto2/2.1.1/libgphoto2_digita.so'...
Opening USB port...
*** ERROR *** Could not claim interface 0 (Success). Make sure no other
program or kernel module (e.g. dc2xx or stv680) is using the device and you
have read/write access to the device.
Freeing camera...
Freeing port...
Closing port...
*** ERROR *** Could not release interface 0 (Success).
Clearing fscache LRU list...
fscache LRU list already empty
Internally deleting all folders from '/'...
I'm not clear on what the error means by the statement that I should make
sure no other program is using the device. Does this mean that I do not want
to install hotplug onto my system for this camera?
--
Avert misunderstanding by calm, poise, and balance.
Reply to: