How to connect UBS Camera
Hello,
I am trying to connect Minolta E203 camera but failed.
I can't understand why it says usb_control/bulk_msg: timeout.
kernel 2.4.20, and murasaki was installed.
hub.c: new USB device 00:11.3-2, assigned address 5
usb.c: USB device 5 (vend/prod 0x4c8/0x723) is not claimed by any active
driver.
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
usb-uhci.c: interrupt, status 2, frame# 415
usb_control/bulk_msg: timeout
scsi1 : SCSI emulation for USB Mass Storage devices
Vendor: MINOLTA Model: DiMAGE E203 Rev: 1.00
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sdb at scsi1, channel 0, id 0, lun 0
SCSI device sdb: 13217 512-byte hdwr sectors (7 MB)
sdb: Write Protect is off
sdb: sdb1
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 5
USB Mass Storage support registered.
I/O error: dev 08:01, sector 0
FAT: unable to read boot sector
Tomoo
--
****** Nomura Technical Management Office Ltd. *****************
Tomoo Nomura nomura@tmo.co.jp http://www.tmo.co.jp/
Phone: +81-78-797-0240 Fax: +81-78-797-0241 @nifty:GBH12257
Worldwide Airline Timetable 'Flight Planner'
European Electronic Timetable 'HAFAS' ValueFax Support
****************************************************************
Reply to: